R0E00008AKCE00EP62 Datasheet, PDF (61/82 Pages) Renesas Technology Corp – Microcomputer Development Environment System

Section 2 Connecting the Emulator with the User System
Section 2 Connecting the Emulator with the User System
Before connecting an E8a emulator (hereafter referred to as emulator) with the user system, a
connector must be installed in the user system so that an user system interface cable can be
connected. When designing the user system, refer to the connector and recommended circuits
shown in this manual.
Before designing the user system, be sure to read the E8a emulator user’s manual and the
hardware manual for related MCUs.
Table 2.1 shows the recommended connector for the emulator.
Table 2.1 Recommended Connector
Type Number
2514-6002
Manufacturer
3M Limited
Specifications
14-pin straight type
Connect pins 2, 4, 6, 10, 12, and 14 of the user system connector to GND firmly on the PCB.
These pins are used as electrical GND and to monitor the connection of the user system connector.
Note the pin assignments of the user system connector.
User system interface cable
Pin 2
User system connector
User system
Pin 1
Figure 2.1 Connecting the User System Interface Cable to the User System
Rev. 1.00 Aug.03, 2009 Page 5 of 22
REJ10J2022-0100