7721 Datasheet, PDF (271/577 Pages) List of Unclassifed Manufacturers – H Bridge Power Module

A-D CONVERTER
12.7 Single sweep mode
12.7 Single sweep mode
In the single sweep mode, the operation for the input voltage from multiple selected analog input pins is
performed, one at a time. The A-D converter is operated in ascending sequence from the AN0 pin. The
A-D conversion interrupt request occurs when the operation for all selected input pins are completed.
12.7.1 Settings for single sweep mode
Figure 12.7.1 shows an initial setting example for registers relevant to the single sweep mode.
When using an interrupt, it is necessary to set the relevant registers to enable the interrupt. Refer to
“CHAPTER 7. INTERRUPTS” for more information.
12–20
7721 Group User’s Manual