M306V5ME-XXXSP Datasheet, PDF (254/263 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER

MITSUBISHI MICROCOMPUTERS
M306V5ME-XXXSP
M306V5EESP
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
and ON-SCREEN DISPLAY CONTROLLER
GZZ SH56 45B <93A0>
MITSUBISHI ELECTRIC SINGLE-CHIP 16-BIT
MICROCOMPUTER M306V5ME-XXXSP
MASK ROM CONFIRMATION FORM
Mask ROM number
The ASCII code for the type No. can be written to EPROM addresses 00000 16 to 0000F16 by specifying the
pseudo-instructions shown in the following table at the beginning of the assembler source program.
EPROM type
27C401
Code entered in
source program
.SECTION ASCIICODE, ROM DATA
.ORG 080000H
.BYTE ' M306V5ME- '
Note: The ROM cannot be processed if the type No. written to the EPROM does not match the type No.
in the check sheet.
In the case of floppy disks
Mitsubishi processes the mask files generated by the mask file generation utilities out of those held on
the floppy disks you give in to us, and forms them into masks. Hence, we assume liability provided that
there is any discrepancy between the contents of these mask files and the ROM data to be burned into
products we produce. Check thoroughly the contents of the mask files you give in.
Prepare 3.5 inches 2HD(IBM format) floppy disks. And store only one mask file in a floppy disk.
File code :
(hex)
Mask file name :
.MSK (alpha-numeric 8-digit)
Note: When using the floppy disks, do not store the type No. to addresses 0000 16 to 0000F16.
2. Mark specification
The mark specification differs according to the type of package. After entering the mark specification on
the separate mark specification sheet (for each package), attach that sheet to this masking check sheet
for submission to Mitsubishi.
For the M306V5ME-XXXSP, submit the 64P4B mark specification sheet.
Rev. 1.0
(3/4)
253