HD404374 Datasheet, PDF (17/161 Pages) Renesas Technology Corp – Low-Voltage AS Microcomputers with On-Chip A/D Converter

HD404374/HD404384/HD404389/HD404082/HD404084 Series
Pin Description
HD404374 and HD404384 Series
Item
Power
supply
Test
Symbol
V_CC
GND
TEST
Reset
RESET
Oscillation OSC₁
OSC₂
X1
Port
X2
D₀–D₉
Pin Number
FP-30D DP-28S^*2
2
2
1
1
11
11
14
12
9
9
10
10
13*¹
—
12*¹
21–30
—
19–28
Interrupt
Wakeup
R0₀, R1₀, R1₃,
R2₀, R2₁, R2₂,
R7₀–R7₃
INT₀
WU₀
15–20,
4–7
21
15
13–18,
4–7
19
13
Serial
interface
Timer
A/D
converter
SCK
SI
SO
TOB,TOC
EVNB
AV_CC
19
20
20
17, 18
16
3
17
18
18
15, 16
14
3
AV_SS
8
8
Other
AN₀–AN₃
NC
4–7
4–7
12*²,
—
13*²
Notes: *1 Applies to HD404374 Series.
*2 Applies to HD404384 Series.
DP-48B
47
45
11
15
7
I/O
—
—
Input
Input
Input
9
Output
13*¹
Input
12*¹
Output
27, 29, 31, 33, 35– I/O
37, 39, 40, 43
17, 19, 21, 23–25, I/O
1–4
27
Input
17
Input
24
25
25
21, 23
19
48
I/O
Input
Output
Output
Input
—
6
—
1–4
Input
5, 8, 10, 12*²,
—
13*², 14, 16, 18,
20, 22, 26, 28, 30,
32, 34, 38, 41, 42,
44, 46
Function
Apply the power supply voltage to this pin.
Connect to ground.
Not for use by the user application.
Connect to GND potential.
Used to reset the MCU.
Internal oscillator input/output pins.
Connect a ceramic resonator, crystal
resonator, or external oscillator circuit.
When using CR oscillation, connect a
resistor.
Realtime clock oscillator input/output pins.
Connect a 32.768 kHz crystal. If 32.768
kHz crystal oscillation is not used, fix the
X1 pin to V_CC and leave the X2 pin open.
I/O pins addressed bit by bit. D₀ to D₃ are
large-current source pins (max. 10 mA),
and D₄ to D₉ are large-current sink pins
(max. 15 mA).
I/O pins, addressed in 4-bit units.
External interrupt input pin
Input pin used for transition from stop
mode to active mode.
Serial interface clock I/O pin
Serial interface receive data input pin
Serial interface transmit data output pin
Timer output pins
Event count input pin
A/D converter power supply pin. Connect
as close as possible to the V_CC pin so as to
be at the same potential as V_CC.
Ground pin for AV_CC. Connect as close as
possible to the GND pin so as to be at the
same potential as GND.
A/D converter analog input pins
Connect to GND potential.
Rev.5.00, Sep.11.2003, page 17 of 161