E32DC200E Datasheet, PDF (51/56 Pages) Omron Electronics LLC – 530 Watts ECL Series

Safety Precautions
Refer to Warranty and Limitations of Liability.
WARNING
This product is not designed or rated for ensuring
safety of persons either directly or indirectly.
Do not use it for such purposes.
Precautions for Correct Use
Do not use the product in atmospheres or environments that exceed
product ratings.
Fiber Units
● Mounting
Tightening Force
The tightening force applied to the Fiber Unit should be as fol-
lows:
Screw-mounting Model
Cylindrical Model
Spring mounting clip
Toothed washers
Retaining screw
(flat head or sunken head)
(M3 max.)
Nuts
(attachment)
Use a proper-sized wrench.
Fiber Units
M6 screw/
6-mm dia. cylinder
M3/M4 screw
2-mm dia./3-mm dia.
cylinder
1.5-mm dia./1-mm dia.
cylinder
E32-L25A
E32-M21
E32-T16
E32-R21
E32-T16W(R)
E32-T16P(R)
E32-T16J(R)
E32-L24S
E32-L24L
E32-T25L
Clamping torque
0.98 N·m max.
0.78 N·m max.
0.29 N·m max.
0.2 N·m max.
0.78 N·m max.
Up to 5 mm to the tip: 0.49 N·m max.
More than 5 mm from the tip:
0.78 N·m max.
0.49 N·m max.
0.39 N·m max.
0.29 N·m max.
Chemical-resistive Models
The following method is recommended to prevent the fluororesin case
from cracking when the Sensor is being secured. Be especially
careful not to crack the case when using screws to secure the Sensor.
Fiber Sensing Head
Fiber Cutting Procedure
Cut a thin fiber as follows:
An attachment is
temporarily fitted to
a thin fiber before
(1) _shipment.
Secure the attach-
ment after adjusting
(2) the position of it in
the direction indicat-
ed by the arrow.
Insert the fiber to be
cut into the E39-F4.
(3)
Finished state
(proper cutting
(4) ^state)
Thin fiber attachment
(E39-F9)
Temporarily fitted
Cutter
(E39-F4)
Three holes for
standard fiber
(2.2-mm dia.)
Approx. 0.5 mm
Two holes for
thin fiber
Insertion direction
Note: Insert the fiber in the direction
indicated by the arrow.
Connection
• Do not pull or press the Fiber Units. The Fiber Units have a
withstand force of 9.8 N or 29.4 N maximum.
• Do not bend the Fiber Unit beyond the permissible bending
radius given under Ordering Information.
• Do not bend the edge of the Fiber Units
(excluding the E32-T@R and E32-D@R).
Correct
20 mm min.
Incorrect
Amplifier Unit
Fiber Unit
20 mm min.
• Do not apply excess force on the Fiber Units.
Correct
Fiber Unit
Nylon wireholder
Incorrect
The Fiber Head could be broken by excessive vibration. To
prevent this, the following is effective:
A one-turn loop can
absorb vibrations.
Tape
51