PIC24FJ256GB108-I Datasheet, PDF (317/352 Pages) Microchip Technology – 64/80/100-Pin, 16-Bit Flash Microcontrollers with USB On-The-Go (OTG)

PIC24FJ256GB110 FAMILY
TABLE 29-6: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD) (CONTINUED)
DC CHARACTERISTICS
Standard Operating Conditions: 2.0V to 3.6V (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
Parameter
No.
Typical⁽¹⁾
Max
Units
Conditions
Power-Down Current (IPD)⁽²⁾
DC62
2.5
7
A
-40°C
DC62a
DC62m
2.5
7
A
+25°C
2.0V⁽³⁾
3.0
7
A
+60°C
DC62b
3.0
7
A
+85°C
DC62c
2.8
7
A
-40°C
DC62d
DC62n
3.0
3.0
7
7
A
A
+25°C
+60°C
2.5V⁽³⁾
RTCC + Timer1 w/32 kHz Crystal:
RTCC + ITI32⁽⁵⁾
DC62e
3.0
7
A
+85°C
DC62f
3.5
10
A
-40°C
DC62g
DC62p
3.5
10
A
+25°C
3.3V⁽⁴⁾
4.0
10
A
+60°C
DC62h
4.0
10
A
+85°C
Note 1: Data in the Typical column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance
only and are not tested.
2: Base IPD is measured with all peripherals and clocks shut down. All I/Os are configured as inputs and
pulled high. WDT, etc., are all switched off, PMSLP bit is clear, and the Peripheral Module Disable (PMD)
bits for all unused peripherals are set.
3: On-chip voltage regulator disabled (ENVREG tied to VSS).
4: On-chip voltage regulator enabled (ENVREG tied to VDD). Low-Voltage Detect (LVD) and Brown-out
Detect (BOD) are enabled.
5: The  current is the additional current consumed when the module is enabled. This current should be
added to the base IPD current.
 2009 Microchip Technology Inc.
DS39897C-page 317