PIC16LF876A-I Datasheet, PDF (130/234 Pages) Microchip Technology – 28/40/44-Pin Enhanced Flash Microcontrollers

PIC16F87XA
11.1 A/D Acquisition Requirements
For the A/D converter to meet its specified accuracy,
the charge holding capacitor (CHOLD) must be allowed
to fully charge to the input channel voltage level. The
analog input model is shown in Figure 11-2. The source
impedance (RS) and the internal sampling switch
impedance (RSS) directly affect the time required to
charge the capacitor CHOLD. The sampling switch
(RSS) impedance varies over the device voltage (VDD);
see Figure 11-2. The maximum recommended
impedance for analog sources is 2.5 k. As the
impedance is decreased, the acquisition time may be
decreased. After the analog input channel is selected
(changed), this acquisition must be done before the
conversion can be started.
To calculate the minimum acquisition time,
Equation 11-1 may be used. This equation assumes
that 1/2 LSb error is used (1024 steps for the A/D). The
1/2 LSb error is the maximum error allowed for the A/D
to meet its specified resolution.
To calculate the minimum acquisition time, TACQ, see
the PIC^® Mid-Range MCU Family Reference Manual
(DS33023).
EQUATION 11-1: ACQUISITION TIME
TACQ = Amplifier Settling Time + Hold Capacitor Charging Time + Temperature Coefficient
TC
TACQ
= TAMP + TC + TCOFF
= 2 s + TC + [(Temperature – 25°C)(0.05 s/°C)]
= CHOLD (RIC + RSS + RS) In(1/2047)
= - 120 pF (1 k + 7 k + 10 k) In(0.0004885)
= 16.47 s
= 2 s + 16.47 s + [(50°C – 25C)(0.05 s/C)
= 19.72 s
Note 1: The reference voltage (VREF) has no effect on the equation since it cancels itself out.
2: The charge holding capacitor (CHOLD) is not discharged after each conversion.
3: The maximum recommended impedance for analog sources is 2.5 k. This is required to meet the pin
leakage specification.
FIGURE 11-2:
ANALOG INPUT MODEL
RS ^ANx
VDD
VT = 0.6V
Sampling
Switch
RIC  1K SS RSS
VA
CPIN
5 pF
VT = 0.6V
ILEAKAGE
± 500 nA
CHOLD
= DAC Capacitance
= 120 pF
VSS
Legend: CPIN
VT
ILEAKAGE
RIC
SS
CHOLD
= input capacitance
= threshold voltage
= leakage current at the pin due to
various junctions
= interconnect resistance
= sampling switch
= sample/hold capacitance (from DAC)
6V
5V
VDD 4V
3V
2V
5 6 7 8 9 10 11
Sampling Switch
(k)
DS39582C-page 130
 2001-2013 Microchip Technology Inc.