PALCE16V8 Datasheet, PDF (24/32 Pages) Advanced Micro Devices – EE CMOS 20-Pin Universal Programmable Array Logic

CAPACITANCE¹
Parameter
Symbol
Parameter Description
Test Conditions
Typ Unit
C_IN
Input Capacitance
C_OUT
Output Capacitance
V_IN = 2.0 V
V_OUT = 2.0 V
V_CC = 5.0 V, T_A = 25 °C,
f = 1 MHz
5
pF
8
pF
Note:
1. These parameters are not 100% tested, but are evaluated at initial characterization and at any time the design is modified where
capacitance may be affected.
SWITCHING CHARACTERISTICS OVER COMMERCIAL AND INDUSTRIAL
OPERATING RANGES¹
Parameter
Symbol
Parameter Description
R _-25
FO ^{Min 2}
Max
Unit
t_PD
t_S
t_H
t_CO
t_WL
t_WH
f_MAX
t_PZX
t_PXZ
t_EA
t_ER
Notes:
Input or Feedback to Combinatorial Output (Note 3)
Setup Time from Input or Feedback to Clock
ES ^{Hold Time}
S _{Clock to Output}
IC _{N LOW}
V Clock Width
E ^{IG HIGH}
D ^{S Maximum}
E Frequency (Notes 4
L _D ^{and 5)}
External Feedback
Internal Feedback (f_CNT)
No Feedback
A _{OE to Output Enable}
G ^W _{OE to Output Disable}
E _{Input to Output Enable Using Product Term Control}
USE ^{N Input to Output Disable Using Product Term Control}
1/(t_S+t_CO)
1/(t_S+t_CF)
1/(t_WH+t_WL)
25
ns
20
ns
0
ns
10
ns
8
ns
8
ns
33.3
MHz
50
MHz
50
MHz
25
ns
25
ns
25
ns
25
ns
1. See “Switching Test Circuit” for test conditions.
2. This parameter is tested in standby mode.
3. This parameter is tested in Standby Mode. When the device is not in Standby Mode, the t_PD will typically be 2 ns faster.
4. These parameters are not 100% tested, but are calculated at initial characterization and at any time the design is modified where
frequency may be affected.
5. t_CF is a calculated value and is not guaranteed. t_CF can be found using the following equation:
t_CF = 1/f_MAX (internal feedback) – t_S.
24
PALCE16V8Z-25 (Com’l, Ind)