V-SERIES Datasheet, PDF (37/45 Pages) Keysight Technologies – Infiniium V-Series Oscilloscopes

37 | Keysight | Infiniium V-Series Oscilloscopes - Data Sheet
Infiniium V-Series Performance Characteristics (Continued)
Trigger
Trigger - oscilloscope channels
Trigger sources
Sensitivity
Edge trigger bandwidth
Minimum pulse width trigger
Hardware
Software (InfiniiScan)
Level range
Internal
Auxiliary
Sweep modes
Display jitter ^{2, 3, 4} (Trigger jitter)
Trigger holdoff range
Trigger qualification (and qualifier)
Trigger actions
Trigger sequences
Trigger - digital channels MSO models
Threshold range (user-defined)
Threshold accuracy
Protocol triggering
Channel 1, channel 2, channel 3, channel 4, and aux
Internal low: 2.0 div p-p for 0 to 22 GHz
Internal high: 0.3 div p-p for 0 to 18 GHz, 1.0 div p-p for > 18 to 22 GHz
Auxiliary: 2.5 GHz
> 20 GHz
< 250 ps
40 ps
± 4 div from center screen or ± 4 V, whichever is smaller
± 5 V, also limit input signal to ± 5 V
Auto (continuous), triggered, single, segmented
230 fs rms
100 ns to 10 s
Single and multiple channels may be logically qualified with any other trigger mode
Specify an action to occur (and the frequency of the action) when a trigger conditions occurs.
Actions include email on trigger and execute "multipurpose" user setting.
Three stage trigger sequences including two-stage hardware (find event (A) and trigger event (B))
and one-stage InfiniiScan software trigger. Supports all hardware trigger modes except “edge
then edge” and “video” and "Gbit serial." Supports “delay (by time)” and “reset (by time or event)”
between two hardware sequences. The minimum latency between “find event (A)” and “trigger event
(B)” is 3 ns.
± 3.75 V in 10 mV increments
± (100 mV + 3% of threshold setting)
All MSO models come standard with protocol trigger for DDR, LPDDR, DDR2, LPDDR2, DDR3,
LPDDR3, DDR4, and LPDDR4
1.  Denotes warranted specifications, all others are typical. Specifications are valid after a 30-minute warm-up period and ± 5 °C from firmware calibration
temperature.
2.  Internal edge trigger mode with JitterFree correction. Value depends on scope settings and trigger signal characteristics, and is equal to TIE value
expressed in the formula above using the minimum Time Scale Accuracy value.
3.  Value shown represents typical Display jitter for DSOV164A at 100 mV/div triggering on 500 mVpp 8 GHz sin wave signal.
4.  Sample rate at maximum. Noise and slew rate determined at fixed-voltage trigger threshold, near middle of signal. Displayed signal not vertically clipped.