V-SERIES Datasheet, PDF (23/45 Pages) Keysight Technologies – Infiniium V-Series Oscilloscopes

23 | Keysight | Infiniium V-Series Oscilloscopes - Data Sheet
Achieve Clarify Faster - Frequency Domain Performance (Continued)
Trying to interpret traditional oscilloscope time-domain specifications can be challenging when trying to determine if a specific scope
can be recommended for RF, µW, and mmW measurements. With correction filters, low-noise front end and spurious free dynamic
range calibration, the V-Series oscilloscopes can be used for wideband frequency domain applications.
Sensitivity / noise density (1 mV/div; —38 dBm range)
Power spectral density measurement at 1.0001 GHz, 1.0001 GHz center frequency,
500 kHz span, and 3 kHz RBW
Noise figure (derived from measurement above)
Signal-to-noise ratio / dynamic range
(—1 dBm, 1 GHz input carrier, 0 dBm scope input range)
1 GHz center frequency, 100 MHz span, 1 kHz RBW, measurement at +20 MHz from
center
Absolute amplitude accuracy (0 to 30 GHz)
Deviation from linear phase (0 to 33 GHz)
Phase noise (at 1 GHz)
10 kHz offset
100 kHz offset
EVM
(802.121 2.4 GHz carrier, 20 MHz wide, 64 QAM)
Spurious responses (—4.6 dBm input signal, —4 dBm input range)
Spurious free dynamic range (SFDR)
1 GHz, —4.6 dBm signal present at input, FFT = 5 GHz span, 3 GHz center, 100 kHz RBW
2nd harmonic distortion
1 GHz input, —4.6 dBm, 5 GHz span, 3 GHz center, 100 KHz RBW
3rd harmonic distortion
1 GHz input, —4.6 dBm, 5 GHz span, 3 GHz center, 100 KHz RBW
Two-tone third-order intermodulation distortion (TOI)
—6.6 dBm input tones, 2.435 and 2.439 GHz, 2 MHz separation, 2.437 GHz center fre-
quency, 10 MHz span, 100 kHz RBW, 8 dBm range
Input match (S₁₁)
(< 50 mV/div, 0 to 30 GHz, no attenuation)
(> = 50 mV/div, 0 to 30 GHz, no attentuation)
V-Series typical values (tested at 33 GHz bandwidth,
1 channel on one scope unless noted)
159 dBm/Hz
+15 dB
+111 dB
± 0.5 dB
± 3 deg
—125 dBc/Hz
—131 dBc/Hz
—47 dB (0.47%)
+67 dB
—51 dBc
—51 dBc
+28 dB
—15 dB; 1.4 VSWR
—21 dB; 1.2 VSWR
Typical frequency domain characteristics for the Infiniium V-Series (not guaranteed, subject to change).
Using data acquired from the V-Series, VSA shows an excellent third
order intercept (TOI) value of 28 dB.
Using data acquired from the V-Series, VSA shows an error vector
magnitude (EVM) for IEEE 802.11 QAM 64 of 0.47%.