V-SERIES Datasheet, PDF (12/45 Pages) Keysight Technologies – Infiniium V-Series Oscilloscopes

12 | Keysight | Infiniium V-Series Oscilloscopes - Data Sheet
Industry’s Most Advanced Probing System
Industry’s lowest-noise active voltage termination
adapter
The N7010A active termination adapter provides a low noise
single-ended cabled measurement solution with 50 Ω voltage
termination (V ) _TERM up to 30 GHz bandwidth. The adapter is
optimized for low amplitude signal measurements with its high
signal-to-noise-ratio and low noise performance. The range of
the V_TERM can be set to ± 4 V, which is ideal for applications such
as HDMI, DisplayPort, MHL and MIPI M-PHY^®, which require
voltage termination. The adapter is compatible with 2.92 mm,
3.5 mm, and SMA connectors, as well as a SMP connector when
an adapter is used.
N7010A active termination adapter provides a low noise single-ended
cabled measurement solution with 50 Ω voltage termination (V ) _TERM up to
30 GHz bandwidth.
Industry’s first magnetically-engaged probe head
and tip
The N2848A/49A QuickTip offers the industry’s first
magnetically-engaged probe head and tip for a quick and secure
connection. The N2848A QuickTip probe head quickly snaps to
the N2849A probe tip, utilizing magnets to connect to the two
sides of the differential signal and ground. Multiple N2849A
probe tips can be installed on a board or device, allowing quick
and reliable measurement of many probe points. The QuickTip
supports InfiniiMode probing when used with the InfiniiMax
III+ probe amplifier and supports differential probing with the
InfiniiMax III probe amplifier.
The N2848A/49A is the industry’s first magnetically-engaged probe
head and tip for a quick and secure connection.
For more information about InfiniiMax III and III+ probes matching the performance of your Infiniium oscilloscope, see the InfiniiMax III
and III+ probes and accessories data sheet with the Keysight publication number 5990-5653EN.