3XX Datasheet, PDF (69/82 Pages) Intel Corporation – Celeron D Processor

6 Features
Features
This chapter contains power-on configuration options and clock control/low power state
descriptions.
6.1
Power-On Configuration Options
Several configuration options can be configured by hardware. The Celeron D processor samples
the hardware configuration at reset, on the active-to-inactive transition of RESET#. For
specifications on these options, refer to Table 6-1.
The sampled information configures the processor for subsequent operation. These configuration
options cannot be changed except by another reset. All resets reconfigure the processor; for reset
purposes, the processor does not distinguish between a "warm" reset and a "power-on" reset.
Table 6-1. Power-On Configuration Option Pins
Configuration Option
Pin^1,2
Output tristate
SMI#
Execute BIST
INIT#
In Order Queue pipelining (set IOQ depth to 1)
A7#
Disable MCERR# observation
A9#
Disable BINIT# observation
A10#
APIC Cluster ID (0-3)
A[12:11]#
Disable bus parking
A15#
Symmetric agent arbitration ID
BR0#
RESERVED
A[6:3]#, A8#, A[14:13]#, A[16:35]#
NOTES:
1. Asserting this signal during RESET# will select the corresponding option.
2. Address pins not identified in this table as configuration options should not be asserted
during RESET#.
6.2
6.2.1
Clock Control and Low Power States
The processor allows the use of AutoHALT, Stop-Grant, and Sleep states to reduce power
consumption by stopping the clock to internal sections of the processor, depending on each
particular state. See Figure 6-1 for a visual representation of the processor low power states.
Normal State—State 1
This is the normal operating state for the processor.
Datasheet
69