300 Datasheet, PDF (20/95 Pages) DB Lectro Inc – SCREW TYPE SERIES

Electrical Specifications
Table 5.
V_CC Static and Transient Tolerance for 775_VR_CONFIG_05A and
775_VR_CONFIG_06 Processors
I_CC (A)
Voltage Deviation from VID Setting (V)^{1, 2, 3, 4}
Maximum Voltage
1.7 mΩ
Typical Voltage
1.75 mΩ
Minimum Voltage
1.8 mΩ
0
0.000
-0.019
-0.038
5
-0.008
-0.027
-0.046
10
-0.016
-0.035
-0.055
15
-0.023
-0.043
-0.063
20
-0.031
-0.051
-0.071
25
-0.039
-0.059
-0.079
30
-0.047
-0.067
-0.088
35
-0.054
-0.075
-0.096
40
-0.062
-0.083
-0.104
45
-0.070
-0.091
-0.112
50
-0.078
-0.099
-0.121
55
-0.085
-0.107
-0.129
60
-0.093
-0.115
-0.137
65
-0.101
-0.123
-0.145
70
-0.109
-0.131
-0.154
75
-0.116
-0.139
-0.162
80
-0.121
-0.144
-0.167
85
-0.132
-0.155
-0.178
90
-0.140
-0.163
-0.187
95
-0.147
-0.171
-0.195
100
-0.155
-0.179
-0.203
NOTES:
1. The loadline specification includes both static and transient limits except for
overshoot allowed as shown in Section 2.5.3.
2. This table is intended to aid in reading discrete points on Figure 1.
3. The loadlines specify voltage limits at the die measured at the VCC_SENSE and
VSS_SENSE lands. Voltage regulation feedback for voltage regulator circuits must be
taken from processor VCC and VSS lands. Refer to the Voltage Regulator-Down
(VRD) 10.1 Design Guide For Desktop and Transportable LGA775 Socket for socket
loadline guidelines and VR implementation details.
4. Adherence to this loadline specification for the Celeron D processor is required to
ensure reliable processor operation.
20
Datasheet