XC2723X Datasheet, PDF (79/109 Pages) Infineon Technologies AG – 16/32-Bit Single-Chip Microcontroller with 32-Bit Performance

XC2723X
XC2000 Family / Econo Line
Electrical Parameters
4) This value includes a hysteresis of approximately 50 mV for rising voltage.
5) V_LV = selected SWD voltage level
6) The limit V_LV - 0.10 V is valid for the OK1 level. The limit for the OK2 level is V_LV - 0.15 V.
Conditions for t_SPO Timing Measurement
The time required for the transition from Power-On to Base mode is called t_SPO. It is
measured under the following conditions:
Precondition: The pad supply is valid, i.e. V_DDPB is above 3.0 V and remains above 3.0 V
even though the XC2723X is starting up. No debugger is attached.
Start condition: Power on reset is removed (PORST = 1).
End condition: External pin toggle caused by first user instruction executed from Flash
after startup.
Conditions for t_SSO Timing Measurement
The time required for the transition from Stopover to Stopover Waked-Up mode is
called t_SSO. It is measured under the following conditions:
Precondition: The Stopover mode has been entered using the procedure defined in the
Programmer’s Guide.
Start condition: Pin toggle on ESR pin triggering the startup sequence.
End condition: External pin toggle caused by first user instruction executed from PSRAM
after startup.
Data Sheet
75
V1.2, 2012-07