XC2723X Datasheet, PDF (69/109 Pages) Infineon Technologies AG – 16/32-Bit Single-Chip Microcontroller with 32-Bit Performance

XC2723X
XC2000 Family / Econo Line
Electrical Parameters
Table 18 Switching Power Consumption
Parameter
Symbol
Values
Unit Note /
Min. Typ. Max.
Test Condition
Power supply current
I_SACT
−
(active) with all peripherals CC
active and EVVRs on
6 + 0.5 8 + mA
x f_SYS1) 0.75 x
f_SYS1)
power_mode=
active ;
voltage_range=
both ²⁾³⁾⁴⁾
Power supply current in I_SSO CC −
stopover mode, EVVRs on
0.7 2.0 mA power_mode=
stopover ;
voltage_range=
both
1) f_SYS in MHz
2) The pad supply voltage pins (V_DDPB) provide the input current for the on-chip EVVRs and the current
consumed by the pin output drivers. A small current is consumed because the drivers input stages are
switched.
3) Please consider the additional conditions described in section "Active Mode Power Supply Current".
4) The pad supply voltage only has a minor influence on this parameter.
Active Mode Power Supply Current
The actual power supply current in active mode not only depends on the system
frequency but also on the configuration of the XC2723X’s subsystem.
Besides the power consumed by the device logic the power supply pins also provide the
current that flows through the pin output drivers.
A small current is consumed because the drivers’ input stages are switched.
Data Sheet
65
V1.2, 2012-07