BTC50010-1TAA_15 Datasheet, PDF (21/31 Pages) Infineon Technologies AG – High-Side Power Connector

5.8
Electrical Characteristics
BTC50010-1TAA
Functional Description
Table 5 Electrical Characteristics: Power Stage
V_S = 13.5 V, T_J = 25 °C, all voltages and currents refer to definitions in Figure 3 (unless otherwise specified).
Parameter
Symbol
Values
Unit Note /
Number
Min. Typ. Max.
Test Condition
Voltage drop
ON-state resistance
V_DROP
–
R_DS(ON)
–
27
36
mV I_L = 30 A
0.9
1.2
mΩ CP pin open
Figure 16
P_5.8.1
P_5.8.2
ON-state resistance hot
R_{DS(ON)_HOT} –
–
2.0
mΩ T_J= 150 °C
Figure 16
P_5.8.3
ON-state resistance in
Infineon^® Reversave™
R_{DS(ON)_REV} –
0.9
–
mΩ V_IN = 0 V
P_5.8.4
ON-state resistance during
inverse operation
R_{DS(ON)_INV} –
0.9
–
mΩ V_IN = 0 V
P_5.8.5
Supply current stand-by
I_{S_OFF}
–
3
12
µA Leakage current flow P_5.8.6
IN pins floating
through OUT pin
Drain to source smart clamp V_DS(CL)
28
–
voltage
V_DS(CL) = V_S - V_OUT
60
V
I_DS = 50 mA
P_5.8.7
T_J= 25 °C to 150°C
Table 6 Electrical Characteristics: Input Stage
V_S = 13.5 V, T_J = 25 °C, all voltages and currents refer to definitions in Figure 3 (unless otherwise specified).
Parameter
Symbol
Values
Unit Note /
Number
Min. Typ. Max.
Test Condition
Input current in ON state
I_{IN_ON}
–
2
IN pins Low
3
mA V_S = 18 V
P_5.8.8
Table 7 Electrical Characteristics: Charge Pump
V_S = 13.5 V, T_J = 25 °C, all voltages and currents refer to definitions in Figure 3 (unless otherwise specified).
Parameter
Symbol
Values
Unit Note /
Number
Min. Typ. Max.
Test Condition
Charge pump current during I_{CP_SW_ON} 0.7
2.2
–
SWITCH ON
Charge pump current during I_{CP_SW_OFF} 350
850
–
SWITCH OFF
Charge pump voltage
V_{CP_ON}
5
–
7
mA V_IN = 0 V
V_CP = 0 V
µA
V_IN = V_S = 8 V
V_CP =V_{CP_ON}
V_OUT = V_S
V
V_IN = 0 V
Figure 22
P_5.8.9
P_5.8.10
P_5.8.11
Data Sheet
Connect FET
21
1.3, 2015-02-06