IC-JRX Datasheet, PDF (13/23 Pages) IC-Haus GmbH – µP INTERFACE WITH 2×4 24V HIGH-SIDE DRIVERS

iC-JRX
µP INTERFACE WITH 2×4 24V HIGH-SIDE DRIVERS
Rev A1, Page 13/23
ABSOLUTE MAXIMUM RATINGS
Values beyond which damage may occur; device operation is not guaranteed.
Item Symbol Parameter
Conditions
G001 VCCD
VCCA
Supply Voltage VCCD, VCCA
G002 VB
Supply Voltage VB
G003 V(IO) Voltage at IO0..7
IOx= off
G004 Idc(IO)
G005 Ipk(IO)
Current in IO0..7
Pulse Current in IOx
IOx= hi (*), τ= 2ms, T$ 2s
G006 Imax() Current in VCCD, VCCA
G007 Imax(VB) Current in VB01, VB23, VB45, VB67
G008 Ic()
Current in Clamping Diodes
CSN, WRN, RDN, A0..4, D0..7,
RESN, CLK, BLFQ, POE
D0..7 with input function
G009 I()
Current in D0..7, INTN
D0..7 with output function
G010 Ilu()
Pulse Current in CSN, WRN, RDN, pulse duration < 10µs,
A0..4, D0..7, RESN, CLK, BLFQ,
all in-/outputs open
INTN, POE, IO0..7 (Latch-Up Strength)
E001 Vd()
ESD Susceptibility at all Pins
MIL-STD-883.D, Method 3015.7;
HBM 100pF discharged through
1.5kΩ
E002 Vb()
Permissible Burst-Transients at IO0..7 according to IEC 1000-4-4
TG1 Tj
Junction Temperature
TG2 Ts
Storage Temperature
(*) IOx= hi: pin set to output, active high, x= 0..7
Fig.
Min.
-0.3
-0.3
-10
1
-500
2
-1
-50
-4
-20
-25
-100
-40
-40
Unit
Max.
7
V
30
V
30
V
100
mA
A
50
mA
4
A
20
mA
25
mA
100
mA
2
kV
4
kV
150
EC
150
EC
THERMAL DATA
Operating Conditions: VCCD= VCCA= 5V ±10%, VB= 19.2..25.2V
GNDA= GNDD= PGND= 0V, alle inputs wired (to hi respectively to lo)
Item Symbol Parameter
Conditions
T1 Ta
T2 Rthja
Operating Ambient Temperature
Range
Thermal Resistance Chip to Ambient
surface mounted on PCB, no
additional cooling areas
Fig.
Unit
Min. Typ. Max.
0
70
EC
55
K/W
All voltages are referenced to ground unless otherwise noted.
All currents into the device pins are positive; all currents out of the device pins are negative.