English
Language : 

RFM42 Datasheet, PDF (63/110 Pages) –
Register 0Ch. GPIO Configuration 2
RFM42/43
Bit
D7
D6
D5
D4
D3
D2
D1
D0
Name
gpiodrv2[1:0]
pup2
Gpio2[4:0]
Type
R/w
R/w
R/w
Reset value = 00000000
Bit
Name
Function
7:6
gpiodrv2[1:0] GPIO Driving Capability Setting.
Pullup Resistor Enable on GPIO2.
5
Pup2
When set to 1 the a 200 kresistor is connected internally between VDD and
the pin if the GPIO is configured as a digital input.
GPIO1 pin Function Select.
00000: Inverted Power-On-Reset (output)
00001: Wake-Up Timer: 1 when WUT has expired (output)
00010: Low Battery Detect: 1 when battery is below threshold setting (output)
00011: Direct Digital Input
00100: External Interrupt, falling edge (input)
00101: External Interrupt, rising edge (input)
00110: External Interrupt, state change (input)
00111: ADC Analog Input
01000: Reserved (Analog Test N Input)
01001: Reserved (Analog Test P Input)
01010: Direct Digital Output
01011: Reserved (Digital Test Output)
01100: Reserved (Analog Test N Output)
01101: Reserved (Analog Test P Output)
01110: Reference Voltage (output)
4:0
gpio2[4:0] 01111: TX Data CLK output to be used in conjunction with TX Data pin
(output)
10000: TX Data input for direct modulation (input)
10001: External Retransmission Request (input)
10010: TX State (output)
10011: TX FIFO Almost Full (output)
10100: Reserved
10101: Reserved
10110: Reserved
10111: Reserved
11000: Reserved
11001: Reserved
11010: Reserved
11011: Reserved
11100: Reserved
11101: VDD
else : GND
63
Tel: +86-755-82973805 Fax: +86-755-82973550 E-mail: sales@hoperf.com http://www.hoperf.com