MC9S08SH32 Datasheet, PDF (73/328 Pages) Freescale Semiconductor, Inc – Microcontrollers

Chapter 5 Resets, Interrupts, and General System Control
5.7.8 System Power Management Status and Control 2 Register
(SPMSC2)
This register is used to report the status of the low voltage warning function, and to configure the stop mode
behavior of the MCU. This register should be written during the user’s reset initialization program to set
the desired controls even if the desired settings are the same as the reset settingsese
7
R
0
W
6
5
4
0
LVDV¹
LVWV
Power-on Reset:
0
0
0
0
LVD Reset:
0
0
u
u
Any other Reset:
0
0
u
u
= Unimplemented or Reserved
3
PPDF
0
0
0
2
1
0
0
PPDACK
0
0
0
0
0
0
u = Unaffected by reset
0
PPDC²
0
0
0
1 _{This bit can be written only one time after power-on reset. Additional writes are ignored.}
2 _{This bit can be written only one time after reset. Additional writes are ignored.}
Figure 5-10. System Power Management Status and Control 2 Register (SPMSC2)
Table 5-11. SPMSC2 Register Field Descriptions
Field
Description
5
LVDV
4
LVWV
3
PPDF
2
PPDACK
0
PPDC
Low-Voltage Detect Voltage Select — This write-once bit selects the low voltage detect (LVD) trip point setting.
It also selects the warning voltage range. See Table 5-12.
Low-Voltage Warning Voltage Select — This bit selects the low voltage warning (LVW) trip point voltage. See
Table 5-12.
Partial Power Down Flag — This read-only status bit indicates that the MCU has recovered from stop2 mode.
0 MCU has not recovered from stop2 mode.
1 MCU recovered from stop2 mode.
Partial Power Down Acknowledge — Writing a 1 to PPDACK clears the PPDF bit
Partial Power Down Control — This write-once bit controls whether stop2 or stop3 mode is selected.
0 Stop3 mode enabled.
1 Stop2, partial power down, mode enabled.
MC9S08SH32 Series Data Sheet, Rev. 2
Freescale Semiconductor
73
PRELIMINARY