MC9S08SH32 Datasheet, PDF (297/328 Pages) Freescale Semiconductor, Inc – Microcontrollers

Appendix A Electrical Characteristics
Table A-7. Supply Current Characteristics (continued)
Num C
Parameter
Symbol
V_DD
(V)
Typ¹
Max²
Unit
Stop2 mode supply current
C
–40°C (C and M suffix)
0.94
–
P
25°C (All parts)
1.25
–
P⁵
85°C (C suffix only)
5 13.4
30
μA
5
P⁵
125°C (M suffix only)
S2I
DD
65
120
C
–40°C (C and Msuffix)
0.83
–
P
25°C (All parts)
1.1
–
P⁵
85°C (C suffix only)
3 11.5
25
μA
P⁵
125°C (M suffix only)
57
100
6
C RTC adder to stop2 or stop3⁶
S23I
5
300
500
nA
DDRTI
3
300
500
nA
7
C LVD adder to stop3 (LVDE = LVDSE = 1) S3I
DDLVD
5
110
180
μA
3
90
160
μA
8
C Adder to stop3 for oscillator enabled⁷
(EREFSTEN =1)
S3I
DDOSC
5,3
5
8
μA
1 _{Typical values are based on characterization data at 25°C. See Figure A-5 through Figure A-7 for typical}
curves across temperature and voltage.
2 _{Max values in this column apply for the full operating temperature range of the device unless otherwise}
noted.
3 _{All modules except ADC active, ICS configured for FBELP, and does not include any dc loads on port pins}
4 _{All modules except ADC active, ICS configured for FEI, and does not include any dc loads on port pins}
5 _{Stop Currents are tested in production for 25 Con all parts. Tests at other temperatures depend upon the}
part number suffix and maturity of the product. Freescale may eliminate a test insertion at a particular
temperature from the production test flow once sufficient data has been collectd and is approved.
6 _{Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the}
higher current wait mode.
7 _{Values given under the following conditions: low range operation (RANGE = 0) with a 32.768kHz crystal}
and low power mode (HGO = 0).
MC9S08SH32 Series Data Sheet, Rev. 2
Freescale Semiconductor
297
PRELIMINARY