FIN1215MTDX Datasheet, PDF (10/20 Pages) Fairchild Semiconductor – LVDS 21-Bit Serializers / De-Serializers

Receiver DC Electrical Characteristics
Typical values are at TA=25°C and with VCC=3.3V. Positive current values refer to the current flowing into device and
negative values means current flowing out of pins. Voltages are referenced to ground unless otherwise specified
(except ΔVOD and VOD). Minimum and maximum values are at over supply voltage and operating temperature ranges
unless otherwise specified.
Symbol
Parameter
Conditions
Min. Typ. Max.
LVTTL/CMOS DC Characteristics
VIH
Input High Voltage
VIL
Input Low Voltage
VOH
Output High Voltage
VOL
Output Low Voltage
VIK
Input Clamp Voltage
IIN
Input Current
IOFF
Input/Output Power-Off
Leakage Current
2.0
VCC
GND
0.8
IOH=-0.4mA
2.7
3.3
IOL=2mA
0.3
IIK=-18mA
-1.5
VIN=0V to 4.6V
-10
10
VCC=0V, All LVTTL Inputs/Outputs
0V to 4.6V
±10
IOS
Output Short-Circuit Current VOUT=0V
-60 -120
Receiver LVDS Input Characteristics
VTH
Differential Input Threshold
HIGH
VTL
Differential Input Threshold
LOW
VICM
Input Common Mode Range
IIN
Input Current
Receiver Supply Current
Figure 6, Table 2
Figure 6, Table 2
Figure 6, Table 2
VIN=2.4V, VCC=3.6V or 0V
VIN=0V, VCC=3.6V or 0V
-100
0.05
100
2.35
±10.0
±10.0
ICCWR
3:21 Receiver Power Supply
Current for Worst Case
Pattern with Load⁽¹⁴⁾
CL=8pF, Figure 7
33MHz
40MHz
65MHz
85MHz⁽¹⁵⁾
66
56
74
75
102
92
125
ICCPDR
Powered Down Supply
Current
/PwrDn=0.8V (RxOut stays LOW)
NA
400
Notes:
14. The power supply current for the receiver can be different due to the number of active I/O channels.
15. 85MHz specification for FIN1218 only.
Units
V
V
V
V
V
μA
μA
μA
mV
mV
V
μA
mA
μA
© 2003 Fairchild Semiconductor Corporation
FIN1215 / FIN1216 / FIN1217 • Rev. 1.0.3
10
www.fairchildsemi.com