XRT4500 Datasheet, PDF (99/99 Pages) Exar Corporation – MULTIPROTOCOL SERIAL NETWORK INTERFACE IC

áç
XRT4500
MULTIPROTOCOL SERIAL NETWORK INTERFACE IC
REV. 1.0.7
REVISIONS
Rev. 1.0.3 -- Updated electrical characteristics, made minor text edits.
Rev. 1.0.4 -- Corrected page formatting problems.
Rev. 1.0.5 -- Corrected table anchor format problem page 46 (caused text to hide), replaced TR3 with TR6
page 41.
Rev. 1.0.6 -- Figure 2: Supply current vs. Temp, edited IDD values.
Rev. 1.0.7 -- Table 1, Receiver specs V.35-- Min Signal level = ±250mV, Max Signal Peak = ±10V, DC Rin =
175Ω. Table 6, Switch S4 V.28 changed from Open to Closed.
NOTICE
EXAR Corporation reserves the right to make changes to the products contained in this publication in order
to improve design, performance or reliability. EXAR Corporation assumes no responsibility for the use of
any circuits described herein, conveys no license under any patent or other right, and makes no represen-
tation that the circuits are free of patent infringement. Charts and schedules contained here in are only for
illustration purposes and may vary depending upon a user’s specific application. While the information in
this publication has been carefully checked; no responsibility, however, is assumed for inaccuracies.
EXAR Corporation does not recommend the use of any of its products in life support applications where
the failure or malfunction of the product can reasonably be expected to cause failure of the life support sys-
tem or to significantly affect its safety or effectiveness. Products are not authorized for use in such applica-
tions unless EXAR Corporation receives, in writing, assurances to its satisfaction that: (a) the risk of injury
or damage has been minimized; (b) the user assumes all such risks; (c) potential liability of EXAR Corpo-
ration is adequately protected under the circumstances.
Copyright 2002 EXAR Corporation
Datasheet September 2002.
Reproduction, in part or whole, without the prior written consent of EXAR Corporation is prohibited.
96