XRD98L61 Datasheet, PDF (9/37 Pages) Exar Corporation – CCD Image Digitizers with CDS, PGA and 12-Bit A/D

Preliminary
XRD98L61
Serial Interface
The XRD9861 uses a three wire serial interface
(LOAD, SDI & SCLK) to access the programmable
features and controls of the chip. The serial interface
uses a 16-bit shift register. The first 6 bits shifted in are
the address bits, the next 10 bits are the data bits. The
address bits select which of the internal registers will
receive the 10 data bits. The interface will only load
data from the shift register into the register array if there
are exactly 16 rising edges of SCLK while LOAD is low.
If more or less rising edges are present, the data is
discarded. There is no checking of the address bits to
ensure a valid register is written to. If the address bits
select an undefined register, the data will be discarded.
There is a readback function (see Serial Interface
Readback section), which outputs the contents of a
selected register on pins DB[11:2] of the digital output
bus.
The following is the procedure for writing to the
serial interface:
1) Force LOAD pin low to enable shift register.
2) Shift in 16 bits, 6 address bits (msb first),
followed by 10 data bits (msb first).
3) Force LOAD pin high to transfer data from the
shift register to the serial interface register array.
Note: There must be exactly 16 rising edges of SCLK
while LOAD is low.
LOAD
SCLK
t_set
SDI
t_L1
t_SCLK
t_L2
t_hold
MSB
LSB
A5 A4 A3 A2 A1 A0 D9 D8 D7 D6 D5 D4 D3 D2 D1 D0
t1
t2
…
t15 t16 ^Time
Figure 3. Serial Interface Timing Diagram
Rev. P4.00
9