XRT73LC00A_08 Datasheet, PDF (55/63 Pages) Exar Corporation – E3/DS3/STS-1 LINE INTERFACE UNIT

XRT73LC00A
E3/DS3/STS-1 LINE INTERFACE UNIT
REV. 1.0.1
5.0 THE MICROPROCESSOR SERIAL INTERFACE
The on-chip Command Registers of the XRT73LC00A DS3/E3/STS-1 Line Interface Unit IC are accessed to
configure the XRT73LC00A into a variety of modes. This section describes the Command Registers and how
to use the Microprocessor Serial Interface.
5.1 Description of the Command Registers
A listing of these Command Registers, their Addresses and their Bit-Formats are listed in Table 5.
TABLE 5: ADDRESSES AND BIT FORMATS OF XRT73LC00A COMMAND REGISTERS
REGISTER BIT-FORMAT
ADDRESS COMMAND REGISTER
TYPE
D4
D3
D2
D1
D0
0x00
CR0
RO
RLOL
RLOS
ALOS
DLOS
DMO
0x01
CR1
R/W
TXOFF
TAOS
TXCLKINV TXLEV
TXBIN
0x02
CR2
R/W
Reserved ENDECDIS ALOSDIS DLOSDIS REQDIS
0x03
CR3
R/W
RNRZ
LOSMUT RCLK2/LCV RCLK2INV RCLK1INV
0x04
CR4
R/W
Reserved STS-1/DS3
E3
LLB
RLB
0x05
CR5
R/W
Reserved Reserved Reserved Reserved Reserved
0x06
CR6
R/W
Reserved Reserved Reserved Reserved Reserved
0x07
CR7
R/W
Reserved Reserved Reserved Reserved Reserved
0x08
CR8
R/W
Reserved Reserved Reserved Reserved Reserved
0x09
CR9
R/W
Reserved Reserved Reserved Reserved Reserved
0x10
CR10
R/W
Reserved Reserved Reserved Reserved Reserved
0x11
CR11
R/W
Reserved Reserved Reserved Reserved Reserved
0x12
CR12
R/W
Reserved Reserved Reserved Reserved Reserved
0x13
CR13
R/W
Reserved Reserved Reserved Reserved Reserved
0x14
CR14
R/W
Reserved Reserved Reserved Reserved Reserved
0x15
CR15
R/W
Reserved Reserved Reserved Reserved Reserved
Address:
The register addresses are in Hexadecimal format.
Type:
The Command Registers are either Read-Only (RO) or Read/Write (R/W) registers.
NOTES:
1. The default value for each of the bit-fields in these registers is “0”.
2. If the REGRESET input pin is asserted, then the contents of the command registers is reset to all "0's" resulting in
the XRT73LC00A operating in the mode corresponding to the default values of the Command Registers.
DESCRIPTION OF BIT-FIELDS FOR EACH COMMAND REGISTER
5.1.1 Command Register - CR0
Bit D4 - RLOL (Receive Loss of Lock Status)
This Read-Only bit-field reflects the lock status of the Clock Recovery Phase-Locked-Loop in the
XRT73LC00A.
50