XR17V258_08 Datasheet, PDF (40/70 Pages) Exar Corporation – 66MHZ PCI BUS OCTAL UART WITH POWER MANAGEMENT SUPPORT

XR17V258
66MHZ PCI BUS OCTAL UART WITH POWER MANAGEMENT SUPPORT
FIGURE 15. TRANSMITTER OPERATION IN NON-FIFO MODE
REV. 1.0.1
Data
Byte
16X or 8X
Clock
(8XMODE
Register)
Transmit
Holding
Register
(THR)
THR Interrupt (ISR bit-1)
Enabled by IER bit-1
Transmit Shift Register (TSR)
M
L
S
S
B
B
TXNOFIFO1
4.6.3 Transmitter Operation in FIFO Mode
The host may fill the transmit FIFO with up to 64 bytes of transmit data. The THR empty flag (LSR bit [5]) is set
whenever the FIFO is empty. The THR empty flag can generate a transmit empty interrupt (ISR bit [1]) when
the amount of data in the FIFO falls below its programmed trigger level (see TXTRG register). The transmit
empty interrupt is enabled by IER bit [1]. The TSR flag (LSR bit [6]) is set when TSR becomes completely
empty. Furthermore, with the RS485 half-duplex direction control enabled (FCTR bit [5]=1) the source of the
transmit empty interrupt changes to TSR empty instead of THR empty. This is to ensure the RTS# output is not
changed until the last stop bit of the last character is shifted out.
4.6.4 Auto RS485 Operation
The auto RS485 half-duplex direction control changes the behavior of the transmitter when enabled by FCTR
bit [5]. It de-asserts RTS# or DTR# after a specified delay indicated in MSR[7:4] following the last stop bit of the
last character that has been transmitted. This helps in turning around the transceiver to receive the remote
station’s response. The delay optimizes the time needed for the last transmission to reach the farthest station
on a long cable network before switching off the line driver. This delay prevents undesirable line signal
disturbance that causes signal degradation. It also changes the transmitter empty interrupt to TSR empty
instead of THR empty.
FIGURE 16. TRANSMITTER OPERATION IN FIFO AND FLOW CONTROL MODE
Transmit
Data Byte
Flow Control Characters
(Xoff1/2 and Xon1/2 Reg.
Auto Software Flow Control
Transmit
FIFO
(64-Byte)
THR Interrupt (ISR bit-1) falls
below Programmed Trigger
Level (TXTRG) and then
when becomes empty. FIFO
is Enabled by FCR bit-0=1
16X or 8X Clock
(8XMODE Register)
Transmit Data Shift Register
(TSR)
Auto CTS Flow Control (CTS# pin)
TXFIFO1
40