XRT83L30_06 Datasheet, PDF (27/78 Pages) Exar Corporation – SINGLE-CHANNEL T1/E1/J1 LH/SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR

REV. 1.0.1
XRT83L30
SINGLE-CHANNEL T1/E1/J1 LH/SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR
FIGURE 12. TRANSMIT CLOCK AND INPUT DATA TIMING
TCLK_R
TCLK_F
TCLK
TPOS/TDATA
or
TNEG
T_SU
T_HO
TRANSMIT HDB3/B8ZS ENCODER
The Encoder function is available in both Hardware and Host modes basis by controlling the TNEG/CODE pin
or CODES interface bit. The encoder is only available in single-rail mode. In E1 mode and with HDB3 encoding
selected, any sequence with four or more consecutive zeros in the input serial data from TPOS/TDATA, will be
removed and replaced with 000V or B00V, where “B” indicates a pulse conforming with the bipolar rule and “V”
representing a pulse violating the rule. An example of HDB3 Encoding is shown in Table 3. In a T1 system, an
input data sequence with eight or more consecutive zeros will be removed and replaced using the B8ZS
encoding rule. An example of Bipolar with 8 Zero Substitution (B8ZS) encoding scheme is shown in Table 4.
Writing a “1” into the CODES interface bit or connecting the TNEG/CODE pin to a “High” level selects the AMI
coding for both E1 or T1 systems.
Input
HDB3 (case1)
HDB3 (case2)
TABLE 3: EXAMPLES OF HDB3 ENCODING
NUMBER OF PULSE BEFORE NEXT 4 ZEROS
odd
even
NEXT 4 BITS
0000
000V
B00V
TABLE 4: EXAMPLES OF B8ZS ENCODING
CASE 1
PRECEDING PULSE
NEXT 8 BITS
Input
+
00000000
B8ZS
000VB0VB
AMI Output
+
000+ -0- +
CASE 2
Input
-
B8ZS
AMI Output
-
DRIVER FAILURE MONITOR (DMO)
00000000
000VB0VB
000- +0+ -
24