LM3S317 Datasheet, PDF (27/379 Pages) List of Unclassifed Manufacturers – Microcontroller

LM3S317 Data Sheet
1.4.3
1.4.3.1
1.4.3.2
1.4.4
1.4.4.1
Each PWM generator block produces two PWM signals that can either be independent signals or
a single pair of complementary signals with dead-band delays inserted. The output of the PWM
generation blocks are managed by the output control block before being passed to the device pins.
CCP Pins (“16-Bit PWM Mode” on page 161)
The General-Purpose Timer Module’s CCP (Capture Compare PWM) pins are software
programmable to support a simple PWM mode with a software-programmable output inversion of
the PWM signal.
Analog Peripherals
To handle analog signals, the LM3S317 controller offers an Analog-to-Digital Converter (ADC) and
an analog comparator.
ADC (Section 11 on page 207)
An analog-to-digital converter (ADC) is a peripheral that converts a continuous analog voltage to a
discrete digital number.
The Stellaris ADC module features 10-bit conversion resolution and supports six input channels,
plus an internal temperature sensor. Four buffered sample sequences allow rapid sampling of up
to six analog input sources without controller intervention. Each sample sequence provides flexible
programming with fully configurable input source, trigger events, interrupt generation, and
sequence priority.
Analog Comparator (Section 14 on page 308)
An analog comparator is a peripheral that compares two analog voltages, and provides a logical
output that signals the comparison result.
The LM3S317 controller provides one independent integrated analog comparator that can be
configured to drive an output or generate an interrupt or ADC event.
A comparator can compare a test voltage against any one of these voltages:
„ An individual external reference voltage
„ A single external reference voltage
„ A shared internal reference voltage
The comparator can provide its output to a device pin, acting as a replacement for an analog
comparator on the board, or it can be used to signal the application via interrupts or triggers to the
ADC to cause it to start capturing a sample sequence. The interrupt generation and ADC triggering
logic is separate. This means, for example, that an interrupt can be generated on a rising edge and
the ADC triggered on a falling edge.
Serial Communications Peripherals
The LM3S317 controller supports both asynchronous and synchronous serial communications
with one fully programmable 16C550-type UART and SSI serial communications.
UART (Section 12 on page 237)
A Universal Asynchronous Receiver/Transmitter (UART) is an integrated circuit used for RS-232C
serial communications, containing a transmitter (parallel-to-serial converter) and a receiver
(serial-to-parallel converter), each clocked separately.
The LM3S317 controller includes one fully programmable 16C550-type UART that supports data
transfer speeds up to 460.8 Kbps. (Although similar in functionality to a 16C550 UART, it is not
register compatible.)
May 4, 2007
27
Preliminary