BCM43362KUBG Datasheet, PDF (29/84 Pages) Cypress Semiconductor – Single-Chip IEEE 802.11™ b/g/n MAC/Baseband/Radio + SDIO

BCM43362 Data Sheet
Generic SPI Mode
Status
The gSPI interface supports status notification to the host after a read/write transaction. This status notification
provides information about any packet errors, protocol errors, information about available packet in the RX
queue, etc. The status information helps in reducing the number of interrupts to the host. The status-reporting
feature can be switched off using a register bit, without any timing overhead. The gSPI bus timing for read/write
transactions with and without status notification are as shown in Figure 13 below and Figure 14 on page 29. See
Table 5 on page 29 for information on status field details.
Figure 13: gSPI Signal Timing Without Status
Write
cs
sclk
mosi
Write-Read _cs
sclk
mosi
miso
Read
cs
sclk
mosi
miso
CC3311 CC3300
CC11 CC00 DD3311 DD3300
DD11 DD00
Command 32 bits
Write Data 16*n bits
CC3311 CC3300
CC00
Command
32 bits
Response
Delay
DD3311 DD3300
DD11 DD00
Read Data 16*n bits
CC3311 CC3300
CC00
Command
32 bits
Response
Delay
DD3311 DD3300
DD00
Read Data
16*n bits
Broadcom_®
February 13, 2015 • 43362-DS106-R
IEEE 802.11 b/g/n MAC/Baseband/Radio + SDIO
Page 28
BROADCOM CONFIDENTIAL