CS4244 Datasheet, PDF (43/63 Pages) Cirrus Logic – 4 In/4 Out Audio CODEC with PCM and TDM Interfaces

4.8.1
4.8.2
4.8.3
CS4244
Interrupt Masking
An occurrence of any of the errors mentioned above will cause the interrupt line to engage in order to no-
tify the system controller that an error has occurred. If it is preferred that the error not cause the interrupt
line to engage, this error can be masked in its respective mask register. It is important to note that, in the
event of an error, the interrupt notification bit for the respective error will reflect the occurrence of the
event, regardless of the setting of the mask bit. Setting the mask bit only prevents the interrupt pin from
being flagged upon the occurrence.
Interrupt Line Operation
As mentioned previously, the interrupt line of the CS4244 will be pulled low or high (depending on the set-
tings of the “INT PIN[1:0]” bits in the "Interrupt Control" register) after an interrupt condition occurs, pro-
vided that the event is not masked in the mask register. If the CS4244’s interrupt line is to be connected
onto a single bus with other devices, it is advisable to use it in the open drain mode of operation. If no
other devices are connected to the interrupt line, it may be used in the CMOS mode of operation. When
used in the open drain configuration, it is necessary to connect a pull-up resistor to this net, which will
ensure a known state on the net when no error is present. Please refer to the typical connection diagram
for the appropriate pull-up resistor value.
Error Reporting and Clearing
In the event of an error, the interrupt line will be engaged - provided the mask bit for that error is not set.
When the interrupt notification registers are read to determine the source of the error, the mask bit for
whichever error occurred will be set automatically by the CS4244. The system controller should begin to
take corrective action to clear the error. Once the error has been cleared, the system controller should
clear the mask bit in the appropriate mask register to ensure that a subsequent occurrence of the error
will cause the interrupt line to engage appropriately. This behavior is detailed in Figure 31 on page 45.
DS900F2
43