AM186EM Datasheet, PDF (45/98 Pages) List of Unclassifed Manufacturers – MICROCONTROLLER BLOCK DIAGRAM

PRELIMINARY
REFRESH CONTROL UNIT
The Refresh Control Unit (RCU) automatically gener-
ates refresh bus cycles. After a programmable period
of time, the RCU generates a memory read request to
the bus interface unit. The RCU is fixed to three wait
states for the PSRAM auto refresh mode.
If the HLDA pin is active when a refresh request is gen-
erated (indicating a bus hold condition), then the
Am186EM and Am188EM microcontrollers deactivate
the HLDA pin in order to perform a refresh cycle. The
external bus master must remove the HOLD signal for
at least one clock in order to allow the refresh cycle to
execute. The sequence of HLDA going inactive while
HOLD is being held active can be used to signal a
pending refresh request.
INTERRUPT CONTROL UNIT
The Am186EM and Am188EM microcontrollers can re-
ceive interrupt requests from a variety of sources, both
internal and external. The internal interrupt controller
arranges these requests by priority and presents them
one at a time to the CPU.
There are six external interrupt sources on the
Am186EM and Am188EM microcontrollers—five
maskable interrupt pins and one nonmaskable interrupt
pin. In addition, there are six total internal interrupt
sources—three timers, two DMA channels, and the
asynchronous serial port—that are not connected to
external pins.
The Am186EM and Am188EM microcontrollers pro-
vide three interrupt sources not present on the Am186
and Am188 microcontrollers. The first is an additional
external interrupt pin (INT4). This pin operates much
like the already existing interrupt pins (INT3–INT0).
The second is an internal watchdog timer interrupt. The
third is an internal interrupt from the asynchronous se-
rial port.
The five maskable interrupt request pins can be used
as direct interrupt requests, or they can be cascaded
with an 82C59A-compatible external interrupt control-
ler if more inputs are needed. An external interrupt con-
troller can be used as the system master by
programming the internal interrupt controller to operate
in slave mode. In all cases, nesting can be enabled so
that interrupt service routines for lower priority inter-
rupts are interrupted by a higher priority interrupt.
Am186/188EM and Am186/188EMLV Microcontrollers
45