AK4569 Datasheet, PDF (21/45 Pages) Asahi Kasei Microsystems – 20-Bit Stereo CODEC with IPGA & HP-AMP

ASAHI KASEI
[AK4569]
„ De-emphasis Filter
The AK4569 includes a digital de-emphasis filter (tc = 50/15µs) by IIR filter corresponding to three sampling frequencies
(32kHz, 44.1kHz and 48kHz). The de-emphasis filter is enabled by setting DEM1-0 bits (Table 16).
„ Bass Boost Function
By controlling BST1-0 bits, the low frequency boost signal can be output from DAC. The setting value is common in Lch
and Rch (Table 17).
The cut-off frequency (fc) of HPF depends on the external resistor and capacitor values. Table 4 shows the relationship of
external resistor, capacitor, fc and output power, where load resistance of headphone is 16Ω. Output level of headphone
amp is 1.5Vpp (typ).
HP-AMP
AK4569
R
C _Headphone
16Ω
Figure 16. External Circuit Example of Headphone
R [Ω]
C [µF]
fc [Hz]
fc [Hz]
BOOST=OFF BOOST=MID
Output Power [mW]
6.8
47
148.6
65
8.7
100
69.8
27
16
47
100
105.8
49.7
43
20
4.4
Table 4. Relationship of external circuit, output power and frequency response
Note: Cut-off frequency (fc) at BOOST=MID is approximate value.
„ System Reset
The AK4569 should be reset once by bringing PDN “L” upon power-up. After exiting reset, VCOM, IPGA, ADC, DAC,
HPL, HPR and MOUT switch to the power-down state. The contents of the control register are maintained until the reset
is done.
ADC exits reset and power down state by MCLK after PMADC bit is changed to “1”, and then ADC is powered up and
the internal timing starts clocking by LRCK “↑”. ADC is in the power-down mode until MCLK and LRCK are input.
DAC also exits reset and power down state when MCLK and LRCK are input after PMDAC= “1”.
MS0292-E-01
- 21 -
2005/07