Z86L9900100ZEM Datasheet, PDF (3/70 Pages) Zilog, Inc. – ICEBOX

Electrical
Safeguards
Follow the precautions listed below to avoid permanent damage to the emulator.
I. Always use a grounding strap to prevent damage resulting from electrostatic discharge (ESD).
II. Power-Up Precautions.
3. Ensure that all power to the emulator and the target application (if any) is turned OFF.
4. Connect the target pod to the target application (if any).
5. Power up the emulator, then press the RESET button.
6. Power up the target application (if any).
III Power-Down Precautions.
When powering down, follow this procedure in the precise order shown below:
1. Power down the target application board (if any).
2. Remove the target pod.
3. Power down the emulator.
NOTES:
1. Refer to the ÒPrecaution ListÓ section of the Product Information sheet for additional operating
precautions specific to various devices.
2. Do not leave the emulator powered up with the RS-232C cable connected to a powered-down PC.
3. Before inserting target pod into target application board, refer to Chapter 2 to determine appropriate
jumper selections and options.
UM005100-IRR0400
iii