Z86L9900100ZEM Datasheet, PDF (23/70 Pages) Zilog, Inc. – ICEBOX

Set-Up and Installation
Hardware Installation
Connect the Power Supply
1. If the power supply provides voltage adjustment:
• Turn the power supply on and adjust it to +5V
• Adjust the setting adjustment for at least 2.5A, if there is a current-limiting adjustment.
2. Turn the power supply off.
3. Locate the power cable (red wire, black wire, and banana plugs on the other end). Plug in
the black banana plug into the black jack on the power supply (labeled COM, GND, or with
the ground symbol). Plug the red plug into the red jack on the power supply (labeled +, +V
or +5V).
4. Plug the white connector on the other end of the cable into the matching 4-pin connector
on the back side of the emulator. (This connection is keyed to ensure against an improper
connection.)
NOTE: The ZiLOG Power Supply Accessory Kit (ZPS05V00ZAC), which is sold separately, provides
a fixed-5V Universal Output Power Supply, accepts 110V to 220V AC input, and includes a power
cable and an in-line jack cable.
CAUTION!
Always check the supply voltage before plugging in the power cord.
Connect the Serial Cable to the PC
Locate the serial cable. Connect the male end to the female connector on the back of the ICE-
BOX, and the female end to either the COM1, COM2, COM3, or COM4 connector of the
host PC.
NOTE: If connector availability is limited to a 9-pin COM1 through COM4, then use either a different
cable or a 25-pin to 9-pin converter. (Available at any electronics store for a nominal fee.)
UM005100-IRR0400
2–5