Z86L9900100ZEM Datasheet, PDF (25/70 Pages) Zilog, Inc. – ICEBOX

Set-Up and Installation
Hardware Installation
Adjust the voltage
If the emulator is powered by its adjustable regulator then the voltage must be manually set.
Set the emulator voltage by performing the following steps:
CAUTION!
If the target and emulator are using separate power supplies then the ICE chip voltage must be
adjusted to match the target’s device voltage. Failure to match the target devices voltage with
the ICE chip’s voltage could result in damage to the emulator, target device or ICE chip.
1. Locate the voltage adjuster on top of the emulator. See Figure 2-3 for the location of the
voltage adjuster.
2. Attach the voltmeter lead to either pin 1 or pin 2 on the J6 jumper and ground.
3. Apply power to the emulator with the target device disconnected.
4. Turn the voltage adjuster’s screw until the voltmeter read-out matches the target device
output voltage.
Connect Logic Analyzer (Optional)
The logic analyzer can either be connected as part of the initial setup, or later as the user con-
tinues working with their design.
Connect to a logic analyzer by performing the following steps:
1. Locate the cable for the logic analyzer.
NOTE: Wear a properly grounded wrist strap or similar ESD protection before continuing.
2. Plug the logic analyzer into the ZiLOG logic analyzer adapter (sold separately from the
Z86L9900100ZEM ICEBOX kit).
NOTE: The logic analyzer adapter can be ordered from customer support by requesting part number
98C0289-001.
3. Plug the cable from the ZiLOG logic analyzer adapter into the emulator. Ensure that the pin
1 marking (as indicated by the red mark on the ribbon cable) matches the pin 1 on the target
board. See Figure 2-3 for the location of the logic analyzer connector.
UM005100-IRR0400
2–7