Z86L9900100ZEM Datasheet, PDF (19/70 Pages) Zilog, Inc. – ICEBOX

Z86L99 ICEBOX USER’S MANUAL
CHAPTER 2
SET-UP AND INSTALLATION
HARDWARE INSTALLATION
Before installing the hardware, refer to Figure 2-1 for a diagram on connecting the emulator
to a PC and power supply; Figure 2-3 provides option jumper locations.
QUICK INSTALLATION INSTRUCTIONS
To install the hardware utilizing a 5VDC wall-adaptor power supply, perform the following.
1. Set the correct jumper setting for powering the ICE chip and target board. See Emulator
connection on page 2-2.
2. Plug a 5.0 VDC 1.5 Amp Wall Power Adaptor to the power connector on the
Z86L9900100ZEM ICEBOX.
3. Turn on the power supply and ensure that it is set to + 5.0V and current limited at 2.5A.
4. Connect the serial cable to the PC.
5. Connect the emulator to the target board (if performing in-circuit emulation).
6. Set up the oscillator and option jumpers.
7. Power up the Z86L9900100ZEM.
UM005100-IRR0400
2–1