Z86L9900100ZEM Datasheet, PDF (29/70 Pages) Zilog, Inc. – ICEBOX

Set-Up and Installation
Emulator Operation
TABLE 2-1. JUMPER SETTINGS (CONTINUED)
Jumper Pin
J1
N/A
JP5
1-2
Position
Out (Default)
In
JP5
2-3 In * (Default)
Description
OTP programming adapter pins
ICE chip uses target oscillator/clock (see Note at the
bottom of the table)
ICE chip uses emulator oscillator/clock (see Note at
the bottom of the table)
NOTE: The user can not run the emulator’s oscillator if the target oscillator or XTAL is connected. At
this time use one of the following methods to set the ICE-chip’s clock:
• To use the emulators oscillator remove the target’s oscillator and connect pin 2 to pin 3 on
the J5 jumper
• To use the target’s oscillator and connect pin 1 to pin 2 on the J5 jumper
Setting Jumpers for Targets
For all targets ensure that JP2 and JP4 are always connected. For 40 pin targets also connect
JP3.
UM005100-IRR0400
2–11