|
W83697HF Datasheet, PDF (95/167 Pages) Winbond – WINBOND I/O | |||
|
◁ |
W83697HF/F
V in
= VCC
Ã
50K â¦
50K⦠+ 34Kâ¦
â
2 .9 8 V
where VCC is set to 5V.
The Pin 61 is connected to 5VSB voltage. W83697HF monitors this voltage and the internal two serial
resistors are 17K ⦠and 33K ⦠so that input voltage to ADC is 3.3V which less than 4.096V of ADC
maximum input voltage.
9.3.2 Monitor negative voltage:
The negative voltage should be connected two series resistors and a positive voltage VREF (is equal to
3.6V). In the Figure 9.2, the voltage V2 and V3 are two negative voltage which they are -12V and -5V
respectively. The voltage V2 is connected to two serial resistors then is connected to another terminal
VREF which is positive voltage. So as that the voltage node N12VIN can be obtain a posedge voltage if
the scales of the two serial resirtors are carefully selected. It is recommanded from Winbond that the
scale of two serial resistors are R3=232K ohms and R4=56K ohm. The input voltage of node N12VIN can
be calculated by following equation.
N12VIN
=
(VREF
+
V2
)
Ã
(
232
232Kâ¦
K⦠+ 56
Kâ¦
)
+ V2
where VREF is equal 3.6V.
If the V2 is equal to -12V then the voltage is equal to 0.567V and the converted hexdecimal data is set
to 35h by the 8-bit ADC with 16mV-LSB.This monitored value should be converted to the real negative
votage and the express equation is shown as follows.
V2
=
N 12VIN â VREF
1â β
Ãβ
Where β is 232K/(232K+56K). If the N2VIN is 0.567 then the V2 is approximately equal to -12V.
The another negative voltage input V3 (approximate -5V) also can be evaluated by the similar method
and the serial resistors can be selected with R5=120K ohms and R6=56K ohms by the Winbond
recommended. The expression equation of V3 With -5V voltage is shown as follows.
V3
=
N5VIN â VREF
1âγ
Ãγ
Where the γ is set to 120K/(120K+56K). If the monitored ADC value in the N5VIN channel is 0.8635,
VREF=3.6V and the parameter γ is 0.6818 then the negative voltage of V3 can be evalated to be -5V.
- 86 -
Publication Release Date: Feb. 2002
Revision 0.70
|
▷ |