W83697HF Datasheet, PDF (22/167 Pages) Winbond – WINBOND I/O

W83697HF
1.4 Serial Port Interface
SYMBOL PIN
I/O
CTSA#
CTSB#
47
IN_t
55
DSRA#
DSRB#
RTSA#
48
IN_t
56
49
I/O_8t
HEFRAS
RTSB#
57
I/O_8t
DTRA#
50
I/O_8t
PNPCSV#
DTRB#
SINA
SINB
SOUTA
58
I/O_8t
51
IN_t
59
52
I/O_8t
PENROM#
SOUTB
PEN48
61
I/O_8t
DCDA#
DCDB#
RIA#
RIB#
53
IN_t
62
54
IN_t
63
FUNCTION
Clear To Send. It is the modem control input.
The function of these pins can be tested by reading bit 4 of the
handshake status register.
Data Set Ready. An active low signal indicates the modem or data
set is ready to establish a communication link and transfer data to
the UART.
UART A Request To Send. An active low signal informs the modem
or data set that the controller is ready to send data.
During power-on reset, this pin is pulled down internally and is
defined as HEFRAS, which provides the power-on value for CR26 bit
6 (HEFRAS). A 4.7 kΩ is recommended if intends to pull up.
(select 4EH as configuration I/O port′s address)
UART B Request To Send. An active low signal informs the modem
or data set that the controller is ready to send data.
UART A Data Terminal Ready. An active low signal informs the
modem or data set that the controller is ready to communicate.
During power-on reset, this pin is pulled down internally and is
defined as _PNPCSV#, which provides the power-on value for CR24
bit 0 (PNPCSV#). A 4.7 kΩ is recommended if intends to pull up.
(clear the default value of FDC, UARTs, and PRT)
UART B Data Terminal Ready. An active low signal informs the
modem or data set that controller is ready to communicate.
Serial Input. It is used to receive serial data through the
communication link.
UART A Serial Output. It is used to transmit serial data out to the
communication link.
During power on reset , this pin is pulled down internally and is
defined as PENROM#, which provides the power on value for CR24
bit 1. A 4.7kΩ is recommended if intends to pull up .
UART B Serial Output. During power-on reset, this pin is pulled
down internally and is defined as PEN48, which provides the power-
on value for CR24 bit 6 (EN48). A 4.7 kΩ resistor is recommended
if intends to pull up.
Data Carrier Detect. An active low signal indicates the modem or
data set has detected a data carrier.
Ring Indicator. An active low signal indicates that a ring signal is
being received from the modem or data set.
- 13 -
Publication Release Date:Feb. 2002
Revision 0.70