W83697HF Datasheet, PDF (68/167 Pages) Winbond – WINBOND I/O

W83697HF/F
5.1.6 Bank0.Reg5 - UART Line Status Register (USR)
Power on default <7:0> = 0000,0000 binary
Bit
Name
7-3 Reserved
2 RX_TO
1 OV_ERR
0 RDR
Read/Write
-
Read/Write
Read/Write
Read/Write
Description
-
Set to 1 when receiver FIFO or frame status FIFO occurs
time-out. Read this bit will be cleared.
Received FIFO overrun. Read to clear.
This bit is set to a logical 1 to indicate received data are
ready to be read by the CPU in the RBR or FIFO. After no
data are left in the RBR or FIFO, the bit will be reset to a
logical 0.
5.1.7 Bank0.Reg6 - Remote Infrared Config Register (RIR_CFG)
Power on default <7:0> = 0000,0000 binary
Bit
Name
7-6 SMPSEL<1:0>
Read/Write
Read/Write
Description
Sampling Mode Select. Select internal decoder
methodology from the internal filter. Selected decoder
mode will determine the receive data format. The sampling
mode is shown as bellow:
SMPSEL<1:0> = 00 T-Period Sample Mode.
SMPSEL<1:0> = 01 Over-Sampling Mode.
SMPSEL<1:0> = 10 Over-Sampling with re-sync.
SMPSEL<1:0> = 11 FIFO Test Mode.
The T-period code format is defined as follows.
(Number of bits) - 1
B7 B6 B5 B4 B3 B2 B1 B0
Bit value
The Bit value is set to 0, then the high pulse will be
received. The Bit value is set to 1, then no energy will be
received. The opposite results will be generated when the
bit RXINV (Bank0.Reg6.Bit0) is set to 1.
- 59 -
Publication Release Date: Feb. 2002
Revision 0.70