W83697HF Datasheet, PDF (142/167 Pages) Winbond – WINBOND I/O

W83697HF/F
After Power-on reset, the value on RTSA# (pin 49) is latched by HEFRAS of CR26. In Compatible PnP,
a specific value (87h) must be written twice to the Extended Functions Enable Register (I/O port address
2Eh or 4Eh). Secondly, an index value (02h, 07h -FFh) must be written to the Extended Functions Index
Register (I/O port address 2Eh or 4Eh same as Extended Functions Enable Register) to identify which
configuration register is to be accessed. The designer can then access the desired configuration
register through the Extended Functions Data Register (I/O port address 2Fh or 4Fh).
After programming of the configuration register is finished, an additional value (AAh) should be written to
EFERs to exit the Extended Function mode to prevent unintentional access to those configuration
registers. The designer can also set bit 5 of CR26 (LOCKREG) to high to protect the configuration
registers against accidental accesses.
The configuration registers can be reset to their default or hardware settings only by a cold reset (pin MR
= 1). A warm reset will not affect the configuration registers.
10.2.2 Extended Functions Enable Registers (EFERs)
After a power-on reset, the W83697HF enters the default operating mode. Before the W83697HF enters
the extended function mode, a specific value must be programmed into the Extended Function Enable
Register (EFER) so that the extended function register can be accessed. The Extended Function
Enable Registers are write-only registers. On a PC/AT system, their port addresses are 2Eh or 4Eh (as
described in previous section).
10.2.3 Extended Function Index Registers (EFIRs), Extended Function Data Registers(EFDRs)
After the extended function mode is entered, the Extended Function Index Register (EFIR) must be
loaded with an index value (02h, 07h-FEh) to access Configuration Register 0 (CR0), Configuration
Register 7 (CR07) to Configuration Register FE (CRFE), and so forth through the Extended Function
Data Register (EFDR). The EFIRs are write-only registers with port address 2Eh or 4Eh (as described in
section 12.2.1) on PC/AT systems; the EFDRs are read/write registers with port address 2Fh or 4Fh (as
described in section 9.2.1) on PC/AT systems.
- 133 -
Publication Release Date: Feb. 2002
Revision 0.70