W25X05CLUXIG-TR Datasheet, PDF (35/47 Pages) Winbond – 1M-BIT SERIAL FLASH MEMORY WITH 4KB SECTORS AND DUAL I/O SPI

W25X10CL
8.1.31 JEDEC ID (9Fh)
For compatibility reasons, the W25X10CL provide several instructions to electronically determine the
identity of the device. The Read JEDEC ID instruction is compatible with the JEDEC standard for SPI
compatible serial memories that was adopted in 2003.
The instruction is initiated by driving the /CS pin low and shifting the instruction code “9Fh”. The
JEDEC assigned Manufacturer ID byte for Winbond (EFh) and two Device ID bytes, Memory Type
(ID15-ID8) and Capacity (ID7-ID0) are then shifted out on the falling edge of CLK with most significant
bit (MSB) first as shown in figure 25. For memory type and capacity values refer to Manufacturer and
Device Identification table.
Figure 25. Read JEDEC ID
- 35 -
Publication Release Date: February 17, 2014
Revision G