W49V002A Datasheet, PDF (3/32 Pages) Winbond – 256K x 8 CMOS FLASH MEMORY WITH LPC INTERFACE

Preliminary W49V002A
FUNCTIONAL DESCRIPTION
Interface Mode Selection And Description
This device can be operated in two interface modes, one is Programmer interface mode, the other is LPC
interface mode. The MODE pin of the device provides the control between these two interface modes.
These interface modes need to be configured before power up or return from #RESET. When MODE pin
is set to high state, the device is in the Programmer mode; while the MODE pin is set to low state(or
leaved no connection), it is in the LPC mode. In Programmer mode, this device just behaves like
traditional flash parts with 8 data lines. But the row and column address inputs are multiplexed, which go
through the address inputs A[10:0]. For LPC mode, It complies with the LPC Interface Specification
Revision 1.0. Through LAD[3:0] to communicate with the system chipset .
Read(Write) Mode
In Programmer interface mode, the read(write) operation of the W49V002A is controlled by #OE (#WE).
The #OE (#WE) is held low for the host to obtain(write) data from(to) the outputs(inputs). #OE is the
output control and is used to gate data from the output pins. The data bus is in high impedance state
when #OE is high. As in the LPC interface mode, the read or write is determined by the "bit 1 of CYCLE
TYPER+DIR".
Reset Operation
The #RESET input pin can be used in some application. When #RESET pin is at high state, the device
is in normal operation mode. When #RESET pin is at low state, it will halt the device and all outputs will
be at high impedance state. As the high state re-asserted to the #RESET pin, the device will return to
read or standby mode, it depends on the control signals.
Chip Erase Operation
The chip-erase mode can be initiated by a six-byte command sequence. After the command loading
cycle, the device enters the internal chip erase mode, which is automatically timed and will be
completed within fast 100 mS (typical). The host system is not required to provide any control or timing
during this operation. If the boot block programming lockout is activated, only the data in the other
memory blocks will be erased to FF(hex) while the data in the boot block will not be erased (remains as
the same state before the chip erase operation). The entire memory array will be erased to FF(hex) by
the chip erase operation if the boot block programming lockout feature is not activated. The device will
automatically return to normal read mode after the erase operation completed. Data polling and/or Toggle
Bits can be used to detect end of erase cycle.
Sector Erase Operation
The seven sectors, one boot block and two parameter blocks and four main blocks, can be erased
individually by initiating a six-byte command sequence. Sector address is latched on the falling #WE
edge of the sixth cycle, while the 30(hex) data input command is latched at the rising edge of #WE.
After the command loading cycle, the device enters the internal sector erase mode, which is
automatically timed and will be completed within fast 150 mS (typical). The host system is not required
to provide any control or timing during this operation. The device will automatically return to normal read
mode after the erase operation completed. Data polling and/or Toggle Bits can be used to detect end of
erase cycle.
Program Operation
The W49V002A is programmed on a byte-by-byte basis. Program operation can only change logical data
Publication Release Date: April 2001
-3-
Revision A1