THS1206IDAR Datasheet, PDF (23/43 Pages) Texas Instruments – 12-BIT, 4 ANALOG INPUT, 6 MSPS, SIMULTANEOUS SAMPLINGANALOG TO-DIGITAL CONVERTERS

www.ti.com
THS1206
SLAS217H – MAY 1999 – REVISED JULY 2003#
ADC CONTROL REGISTER
The THS1206 contains two 10-bit wide control registers (CR0, CR1) in order to program the device into the desired mode.
The bit definitions of both control registers are shown in Table 7.
Table 7. Bit Definitions of Control Register CR0 and CR1
REG
CR0
CR1
BIT 9
TEST1
RBACK
BIT 8
TEST0
OFFSET
BIT 7
SCAN
BIN/2’s
BIT 6
DIFF1
R/W
BIT 5
DIFF0
DATA_P
BIT 4
CHSEL1
DATA_T
BIT 3
CHSEL0
TRIG1
BIT 2
PD
TRIG0
BIT 1
MODE
OVFL/FRST
BIT 0
VREF
RESET
Writing to Control Register 0 and Control Register 1
The 10-bit wide control register 0 and control register 1 can be programmed by addressing the desired control register and
writing the register value to the ADC. The addressing is performed with the upper data bits D10 and D11, which function
in this case as address lines RA0 and RA1. During this write process, the data bits D0 to D9 contain the desired control
register value. Table 8 shows the addressing of each control register.
Table 8. Control Register Addressing
D0 – D9
Desired register value
Desired register value
Desired register value
Desired register value
D10/RA0
0
1
0
1
D11/RA1
0
0
1
1
Addressed Control Register
Control register 0
Control register 1
Reserved for future
Reserved for future
23