LP3907_14 Datasheet, PDF (23/57 Pages) Texas Instruments – Dual High-Current Step-Down DC/DC and Dual Linear Regulator with I2C-Compatible Interface

LP3907
www.ti.com
SNVS511N – JUNE 2007 – REVISED AUGUST 2011
or
B. The peak PMOS switch current drops below the I_MODE level
(Typically
I_MODE
<
66
mA
+
V_IN
160:
)
(3)
During PFM operation, the converter positions the output voltage slightly higher than the nominal output voltage
during PWM operation, allowing additional headroom for voltage drop during a load transient from light to heavy
load. The PFM comparators sense the output voltage via the feedback pin and control the switching of the output
FETs such that the output voltage ramps between 0.8% and 1.6% (typical) above the nominal PWM output
voltage. If the output voltage is below the ‘low’ PFM comparator threshold, the PMOS power switch is turned on.
It remains on until the output voltage exceeds the ‘high’ PFM threshold or the peak current exceeds the I_PFM level
set for PFM mode. The typical peak current in PFM mode is:
I_PFM
=
66
mA
+
V_IN
80:
(4)
Once the PMOS power switch is turned off, the NMOS power switch is turned on until the inductor current ramps
to zero. When the NMOS zero-current condition is detected, the NMOS power switch is turned off. If the output
voltage is below the ‘high’ PFM comparator threshold (see figure below), the PMOS switch is again turned on
and the cycle is repeated until the output reaches the desired level. Once the output reaches the ‘high’ PFM
threshold, the NMOS switch is turned on briefly to ramp the inductor current to zero and then both output
switches are turned off and the part enters an extremely low power mode. Quiescent supply current during this
‘sleep’ mode is less than 30µA, which allows the part to achieve high efficiencies under extremely light load
conditions. When the output drops below the ‘low’ PFM threshold, the cycle repeats to restore the output voltage
to ~1.6% above the nominal PWM output voltage.
If the load current should increase during PFM mode (see figure below) causing the output voltage to fall below
the ‘low2’ PFM threshold, the part will automatically transition into fixed-frequency PWM mode.
SW1, SW2 OPERATION
SW1 and SW2 have selectable output voltages ranging from 0.8V to 3.5V (typ.). Both SW1 and SW2 in the
LP3907 are I²C register controlled and are enabled by default through the internal state machine of the LP3907
following a Power-On event that moves the operating mode to the Active state. (see Power On Sequence). The
SW1 and SW2 output voltages revert to default values when the power on sequence has been completed. The
default output voltage for each buck converter is factory programmable. (See Application Notes).
SW1, SW2 CONTROL REGISTERS
SW1, SW2 can be enabled/disabled through the corresponding control register.
The Modulation mode PWM/PFM is by default automatic and depends on the load as described above in the
functional description. The modulation mode can be overridden by setting I²C bit to a logic 1 in the corresponding
buck control register, forcing the buck to operate in PWM mode regardless of the load condition.
Copyright © 2007–2011, Texas Instruments Incorporated
Product Folder Links: LP3907
Submit Documentation Feedback
23