CC2640R2F Datasheet, PDF (20/64 Pages) Texas Instruments – SimpleLink Bluetooth low energy Wireless MCU

CC2640R2F
SWRS204 – DECEMBER 2016
www.ti.com
1-Mbps GFSK (Bluetooth low energy) – RX (continued)
Measured on the TI CC2650EM-5XD reference design with T_c = 25°C, V_DDS = 3.0 V, f_RF = 2440 MHz, unless otherwise noted.
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX UNIT
Out-of-band blocking ⁽³⁾
30 MHz to 2000 MHz
–20
dBm
Out-of-band blocking
2003 MHz to 2399 MHz
–5
dBm
Out-of-band blocking
2484 MHz to 2997 MHz
–8
dBm
Out-of-band blocking
3000 MHz to 12.75 GHz
–8
dBm
Intermodulation
Wanted signal at 2402 MHz, –64 dBm. Two
interferers at 2405 and 2408 MHz respectively, at
the given power level
–34
dBm
Spurious emissions,
30 to 1000 MHz
Conducted measurement in a 50-Ω single-ended
load. Suitable for systems targeting compliance with
EN 300 328, EN 300 440 class 2, FCC CFR47, Part
15 and ARIB STD-T-66
–71
dBm
Spurious emissions,
1 to 12.75 GHz
Conducted measurement in a 50-Ω single-ended
load. Suitable for systems targeting compliance with
EN 300 328, EN 300 440 class 2, FCC CFR47, Part
15 and ARIB STD-T-66
–62
dBm
RSSI dynamic range
70
dB
RSSI accuracy
±4
dB
(3) Excluding one exception at F_wanted / 2, per Bluetooth Specification.
5.11 1-Mbps GFSK (Bluetooth low energy) – TX
Measured on the TI CC2650EM-5XD reference design with T_c = 25°C, V_DDS = 3.0 V, f_RF = 2440 MHz, unless otherwise noted.
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX UNIT
Output power, highest setting
Differential mode, delivered to a single-ended 50-Ω load
through a balun
5
dBm
Output power, highest setting
Output power, lowest setting
Measured on CC2650EM-4XS, delivered to a single-ended
50-Ω load
Delivered to a single-ended 50-Ω load through a balun
f < 1 GHz, outside restricted bands
2
dBm
–21
dBm
–43
dBm
Spurious emission conducted ^{f < 1 GHz, restricted bands ETSI}
measurement ⁽¹⁾
f < 1 GHz, restricted bands FCC
–65
dBm
–76
dBm
f > 1 GHz, including harmonics
–46
dBm
(1) Suitable for systems targeting compliance with worldwide radio-frequency regulations ETSI EN 300 328 and EN 300 440 Class 2
(Europe), FCC CFR47 Part 15 (US), and ARIB STD-T66 (Japan).
5.12 2-Mbps GFSK (Bluetooth 5) – RX
Measured on the TI CC2650EM-5XD reference design with T_c = 25°C, V_DDS = 3.0 V, f_RF = 2440 MHz, unless otherwise noted.
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX UNIT
Receiver sensitivity
Differential mode. Measured at the CC2650EM-5XD
SMA connector, BER = 10^–3
–92
dBm
Receiver saturation
Differential mode. Measured at the CC2650EM-5XD
SMA connector, BER = 10^–3
4
dBm
Frequency error tolerance
Difference between the incoming carrier frequency and
the internally generated carrier frequency
–300
500 kHz
Data rate error tolerance
Difference between incoming data rate and the
internally generated data rate
–1000
1000 ppm
Co-channel rejection⁽¹⁾
Wanted signal at –67 dBm, modulated interferer in
channel, BER = 10^–3
–7
dB
Selectivity, ±2 MHz⁽¹⁾
Wanted signal at –67 dBm, modulated interferer at
±2 MHz, Image frequency is at –2 MHz BER = 10^–3
8 / 4 ⁽²⁾
dB
(1) Numbers given as I/C dB.
(2) X / Y, where X is +N MHz and Y is –N MHz.
20
Specifications
Submit Documentation Feedback
Product Folder Links: CC2640R2F
Copyright © 2016, Texas Instruments Incorporated