CC2640R2F Datasheet, PDF (17/64 Pages) Texas Instruments – SimpleLink Bluetooth low energy Wireless MCU

www.ti.com
CC2640R2F
SWRS204 – DECEMBER 2016
5.6 125-kbps Coded (Bluetooth 5) – RX
Measured on the TI CC2650EM-5XD reference design with T_c = 25°C, V_DDS = 3.0 V, f_RF = 2440 MHz, unless otherwise noted.
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX UNIT
Receiver sensitivity
Differential mode. Measured at the CC2650EM-5XD
SMA connector, BER = 10^–3
–103
dBm
Receiver saturation
Differential mode. Measured at the CC2650EM-5XD
SMA connector, BER = 10^–3
>5
dBm
Frequency error tolerance
Difference between the incoming carrier frequency
and the internally generated carrier frequency
–260
310 kHz
Data rate error tolerance
Difference between incoming data rate and the
internally generated data rate (37-byte packets)
–260
260 ppm
Data rate error tolerance
Difference between incoming data rate and the
internally generated data rate (255-byte packets)
–140
150 ppm
Co-channel rejection ⁽¹⁾
Wanted signal at –79 dBm, modulated interferer in
channel, BER = 10^–3
–3
dB
Selectivity, ±1 MHz ⁽¹⁾
Wanted signal at –79 dBm, modulated interferer at
±1 MHz, BER = 10^–3
9 / 5 ⁽²⁾
dB
Selectivity, ±2 MHz ⁽¹⁾
Wanted signal at –79 dBm, modulated interferer at
±2 MHz, Image frequency is at –2 MHz, BER = 10^–3
43 / 32⁽²⁾
dB
Selectivity, ±3 MHz ⁽¹⁾
Wanted signal at –79 dBm, modulated interferer at
±3 MHz, BER = 10^–3
47 / 42⁽²⁾
dB
Selectivity, ±4 MHz ⁽¹⁾
Wanted signal at –79 dBm, modulated interferer at
±4 MHz, BER = 10^–3
46 / 47⁽²⁾
dB
Selectivity, ±6 MHz ⁽¹⁾
Wanted signal at –79 dBm, modulated interferer at
±6 MHz, BER = 10^–3
49 / 46⁽²⁾
dB
Alternate channel rejection, ±7 Wanted signal at –79 dBm, modulated interferer at ≥
MHz ⁽¹⁾
±7 MHz, BER = 10^–3
50 / 47⁽²⁾
dB
Selectivity, image frequency⁽¹⁾
Wanted signal at –79 dBm, modulated interferer at
image frequency, BER = 10^–3
32
dB
Selectivity, image frequency
±1 MHz⁽¹⁾
Note that Image frequency + 1 MHz is the Co-
channel –1 MHz. Wanted signal at –79 dBm,
modulated interferer at ±1 MHz from image
frequency, BER = 10^–3
5 / 32⁽²⁾
dB
Blocker rejection, ±8 MHz and Wanted signal at –79 dBm, modulated interferer at
above ⁽¹⁾
±8 MHz and above, BER = 10^–3
Out-of-band blocking ⁽³⁾
30 MHz to 2000 MHz
>46
dB
–40
dBm
Out-of-band blocking
2003 MHz to 2399 MHz
–19
dBm
Out-of-band blocking
2484 MHz to 2997 MHz
–22
dBm
Intermodulation
Wanted signal at 2402 MHz, –76 dBm. Two
interferers at 2405 and 2408 MHz respectively, at
the given power level
–42
dBm
(1) Numbers given as I/C dB.
(2) X / Y, where X is +N MHz and Y is –N MHz.
(3) Excluding one exception at F_wanted / 2, per Bluetooth Specification.
Copyright © 2016, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: CC2640R2F
Specifications
17