LM3S1636_13 Datasheet, PDF (171/655 Pages) Texas Instruments – Stellaris Microcontroller

OBSOLENTREN:DT:I Nhaost rdeicsocomnmtiennudeeddpfroordnuecwtiodneosifgtnhsis. device.
Stellaris^® LM3S1636 Microcontroller
software a mechanism to adjust the regulated value, in small increments (VSTEP), over the range
of 2.25 V to 2.75 V (inclusive)—or 2.5 V ± 10%. The adjustment is made by changing the value of
the VADJ field in the LDO Power Control (LDOPCTL) register.
Figure 5-4 on page 171 shows the power architecture.
Note: On the printed circuit board, use the LDO output as the source of VDD25 input. Do not use
an external regulator to supply the voltage to VDD25. In addition, the LDO requires decoupling
capacitors. See “On-Chip Low Drop-Out (LDO) Regulator Characteristics” on page 609.
VDDA must be supplied with 3.3 V, or the microcontroller does not function properly. VDDA
is the supply for all of the analog circuitry on the device, including the LDO and the clock
circuitry.
Figure 5-4. Power Architecture
VDD25
VDD25
VDD25
VDD25
LDO
Internal
Logic and PLL
GND
GND
GND
GND
Low-noise
LDO
+3.3V
VDDA
VDDA
Analog circuits
GNDA
GNDA
VDD
GND
VDD
GND
VDD
I/O Buffers
GND
VDD
GND
5.2.4
Clock Control
System control determines the control of clocks in this part.
July 24, 2012
171
Texas Instruments-Production Data