HPC3130A Datasheet, PDF(21/41 Page) Texas Instruments

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

HPC3130A Datasheet, PDF (21/41 Pages) Texas Instruments – PCI HOT PLUG CONTROLLER

◁

HPC3130A

PCI HOT PLUG CONTROLLER

SCPS055 â NOVEMBER 1999

connection sequencing (continued)

IDLEREQ, IDLEGNT, FRAME, and IRDY pins are not connected in manual mode. In contrast, during automatic

connection, the HPC3130A requests the PCIBus to make sure it is idle before it sequences through the

connection sequence.

In manual mode, software has to perform each part of the connection sequence. Figure 9 is an example of the

manual connection sequence. There could be several other ways to implement this protocol.

PCI_CLK

PWRON/OFF

PWRGOOD

SLOTRST

CLKON

REQ64ON

SLOTREQ64

BUS_CTL

BUSON

Figure 9. Manual Connection Sequencing

disconnecting sequence

The HPC3130A provides two mechanisms to isolate a PCI slot from the PCI bus so an addâin card can be

removed. One of the mechanisms is called manual sequencing and is enabled by default. This mechanism

allows the software to control the entire disconnect sequence. This means it is the softwareâs responsibility to

remove a powered slot from the PCI bus without any impact to the system.

The second mechanism is called autosequencing and can be enabled by programming either Auto-Sequence

1 or Auto-Sequence 2 in the general configuration register. Unlike the connection sequence, which has two

different autoconnection sequencing modes, the autodisconnect sequence has only one mode of operation.

The steps in the autodisconnect sequence are as follows:

1. Software may assert SLOTRST to the appropriate slot by writing a 0 to the SLOTRST_O bit in the hot-plug

control register. This is optional.

2. Next the software must set the BUS_CTL bit in the hot-plug control register to a 1.

3. Once the BUS_CTL bit is set to a 1, the HPC3130A asserts IDLEREQ.

4. Once IDLEGNT is asserted and FRAME and IRDY are deasserted, the HPC3130A deasserts BUSON and

CLKON and asserts REQ64ON to isolate the slot from the PCI bus.

5. The HPC3130A then drives PWRON/OFF low to power off the slot.

â¢ POST OFFICE BOX 655303 DALLAS, TEXAS 75265

▷