71M6531D_10 Datasheet, PDF (68/120 Pages) Teridian Semiconductor Corporation – Energy Meter IC

Data Sheet 71M6531D/F-71M6532D/F
FDS 6531/6532 005
The polarity of the OPT_TX and OPT_RX pins can be inverted with the configuration bits, OPT_TXINV
and OPT_RXINV, respectively.
The OPT_TX output may be modulated at 38 kHz when system power is present. Modulation is not
available in BROWNOUT mode. The OPT_TXMOD bit enables modulation. The duty cycle is controlled
by OPT_FDC[1:0], which can select 50%, 25%, 12.5% and 6.25% duty cycle. A 6.25% duty cycle means
OPT_TX is low for 6.25% of the period. The OPT_RX pin uses digital signal thresholds. It may need an
analog filter when receiving modulated optical signals.
With modulation, an optical emitter can be operated at higher current than nominal, enabling it to
increase the distance along the optical path.
If operation in BROWNOUT mode is desired, the external components should be connected to V3P3D.
V3P3SYS
71M6531D/F or 71M6532D/F
OPT_RX
100 pF 10 kΩ
R₁
Phototransistor
V3P3SYS
OPT_TX
R₂
LED
Figure 36: Connection for Optical Components
3.10 Connecting the V1 Pin
A voltage divider should be used to establish that V1 is in a safe range when the meter is in MISSION
mode (see Figure 37). V1 must be lower than 2.9 V in all cases in order to keep the hardware watchdog
timer enabled. The resistor divider ratio must be chosen so that V1 crosses the VBIAS threshold when
V3P3 is near the minimum supply voltage (3.0 VDC). A series resistor (R3) provides additional hysteresis,
and a capacitor to ground (C1) is added for enhanced EMC immunity.
The amount of hysteresis depends on the choice of R1 and R3: If V1 < VBIAS, approximately 1 µA will
flow into the on-chip V1 comparator causing a voltage drop. If V1 ≥ VBIAS, almost no current will flow
into the comparator. The voltage drop will require V3P3 to be slightly higher for V1 to cross the VBIAS
threshold when V3P3 is rising as compared to when V3P3 is falling. Maintaining sufficient hysteresis
helps to eliminate rapid mode changes which may occur in cases where the power supply is unstable with
V1 close to the VBIAS threshold point.
R₁
R₃
V3P3
16.9kΩ
R₂ ^{20kΩ C}1
V1
100pF
GND
Figure 37: Voltage Divider for V1
68
© 2005-2010 TERIDIAN Semiconductor Corporation
v1.3