71M6531D_10 Datasheet, PDF (23/120 Pages) Teridian Semiconductor Corporation – Energy Meter IC

FDS 6531/6532 005
Data Sheet 71M6531D/F-71M6532D/F
Accumulator (ACC, A, SFR 0xE0):
ACC is the accumulator register. Most instructions use the accumulator to hold the operand. The
mnemonics for accumulator-specific instructions refer to accumulator as A, not ACC.
B Register (SFR 0xF0):
The B register is used during multiply and divide instructions. It can also be used as a scratch-pad register
to hold temporary data.
Program Status Word (PSW, SFR 0xD0):
This register contains various flags and control bits for the selection of the register banks (see Table 11).
PSW Bit
7
6
5
4
3
2
1
0
Symbol
CV
AC
F0
RS1
RS0
OV
-
P
Table 11: PSW Bit Functions (SFR 0xD0)
Function
Carry flag.
Auxiliary Carry flag for BCD operations.
General-purpose Flag 0 available for user.
F0 is not to be confused with the F0 flag in the CESTATUS register.
Register bank select control bits. The contents of RS1 and RS0 select the
working register bank:
RS1/RS0
Bank selected
Location
00
Bank 0
0x00 – 0x07
01
Bank 1
0x08 – 0x0F
10
Bank 2
0x10 – 0x17
11
Bank 3
0x18 – 0x1F
Overflow flag.
User defined flag.
Parity flag, affected by hardware to indicate odd or even number of one bits in
the Accumulator, i.e. even parity.
Stack Pointer (SP, SFR 0x81):
The stack pointer is a 1-byte register initialized to 0x07 after reset. This register is incremented before
PUSH and CALL instructions, causing the stack to begin at location 0x08.
Data Pointer:
The data pointers (DPTR and DPRT1) are 2 bytes wide. The lower part is DPL(SFR 0x82) and DPL1
(SFR0x84) and the highest is DPH (SFR0x83) and DPH1 (SFR 0x85). The data pointers can be loaded as
two registers (e.g. MOV DPL,#data8). They are generally used to access external code or data space
(e.g. MOVC A,@A+DPTR or MOVX A,@DPTR respectively).
Program Counter:
The program counter (PC) is 2 bytes wide and initialized to 0x0000 after reset. The PC is incremented
when fetching operation code or when operating on data from program memory.
Port Registers:
The I/O ports are controlled by Special Function Registers P0, P1 and P2 as shown in Table 12. The contents
of the SFR can be observed on corresponding pins on the chip. Writing a 1 to any of the ports causes the
corresponding pin to be at high level (V3P3). Writing a 0 causes the corresponding pin to be held at a low
level (GND). The data direction registers DIR0, DIR1 and DIR2 define individual pins as input or output
pins (see Sections 1.5.7 Digital I/O – 71M6531D/F or 1.5.8 Digital I/O – 71M6532D/F).
v1.3
© 2005-2010 TERIDIAN Semiconductor Corporation
23